Rae AutoRAE 2 Quick Start Manual
Also see for AutoRAE 2: User guide
      |
by HoneywellSetupBefore using the AutoRAE 2 Controller and AutoRAE 2 Cradle(s) to bump test or calibrate ToxiRAE Pro-familyand/or QRAE 3 and/or MultiRAE-family (pumped versions) instruments, follow the instructions in theAutoRAE 2 User’s Guide for programming the gas configurations. The steps to follow for assembly and gasconfiguration, as well as functionality, are the same for all cradles.ConnectionsAssemble the system. Connect the AutoRAE 2 Controller to any Cradles, and then connect the Terminator. ForToxiRAE Pro Cradles, insert the appropriate adapter.Important! Make sure an SD card is installed in the AutoRAE 2 Controller. The system cannot operate if an SDcard is not installed. For installation instructions, consult the AutoRAE 2 User’s Guide. Make sure the AutoRAE 2Controller’s RTC (real-time clock) has been set in ProRAE Studio II before its first use.Calibration gas cylinders(each must have a demand-flow regulator)Attach Controller to Cradle(s) and thenattach Terminal Adapter to last Cradle.Insert and tightenscrews, and then putcaps over screws.Press filter ontoreceptacle atend of CradlePlug the barrel fromAC adapter into jack.Then plug its cord intothe transformer, andthe transformer intoAC power source.ExhaustAutoRAE 2ControllerAutoRAE 2Cradles(maximumof 10)Press filter ontoreceptacle at endof ControllerThe ToxiRAE Pro Cradlerequires an adapter to beinserted in the capturemechanism. ToxiRAE Proand ToxiRAE Pro LEL (L)and ToxiRAE Pro PID (R). |
Related manuals for Rae AutoRAE 2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine