Rain Bird LXME2 Quick Start Manual

Also see for LXME2: Installation, programming & operation guide

Rain Bird LXME2 Quick Start Manual Manual pdf 1 page image

NOTICE:Changes or modifications not expressly approved by Rain Birdcould void the user’s authority to operate the equipment.The current date and time on the controller is retained bya long-life lithium battery, which must be disposed of inaccordance with local regulations.CAUTION:This appliance is not intended for use by persons (includingchildren) with reduced physical, sensory or mental capabilities,or lack of experience and knowledge, unless they have beengiven supervision or instruction concerning use of the applianceby a person responsible for their safety.Children should be supervised to ensure that they do not playwith the appliance.For controllers not provided with supply cord, the fixedinstallation must include a disconnecting device for all threepoles suitable for overvoltage category III protection.WARNINGThe LXME2 controller must be properly surge protectedand grounded. Doing so can help prevent damage to thecontroller and irrigation system and also significantly reducetroubleshooting, repair time and expense. Failure to do so couldresult in failure of your controller and voiding the warranty.Electric shock can cause severe injury or death. Make sure powersupply is turned OFF before connecting power wires.All electrical connections and wiring runs must be madeaccording to local building codes.If the supply cord of ILXME2AU or ILXME2PAU models isdamaged, it must be replaced by the manufacturer, its serviceagent or similarly qualified person in order to avoid hazard.Replace with the following: Flexible supply cord H05VVF,minimum wire size of 0.75mm2 (18 AWG). For direct connectionwiring, the minimum wire size is 0.75mm2 (18 AWG).This controller uses a non-replaceable lithium battery.Lithium batteries are hazardous and can cause severeor fatal injuries in 2 hours or less if it is swallowed orplaced inside any part of the body. Medical attentionshould be sought immediately if this is suspected.Keep batteries away from childrenRegulatory information47 CFR § 2.1077 Compliance InformationUnique Identifier: ESPLXME2/ ESPLXME2PThis device complies with Part 15 of the FCC Rules. Operationis subject to the following two conditions: (1) This device maynot cause harmful interference, and (2) this device must acceptany interference received, including interference that may causeundesired operation.Note: This equipment has been tested and found to complywith the limits for a Class B digital device, pursuant to part15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in aresidential installation. This equipment generates, uses andcan radiate radio frequency energy and, if not installed andused in accordance with the instructions, may cause harmfulinterference to radio communications. However, there isno guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interferenceto radio or television reception, which can be determined byturning the equipment off and on, the user is encouraged totry to correct the interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit differentfrom that to which the receiver is connected.• Consult the dealer or an experienced radio/TV technician forhelp.Page 2 Page 3 Pages 4-5 Pages 6-12Controller &ProgrammingOverviewBasicProgrammingInstallation ProgrammingChartLXME2 ControllerQuick Start Guide &Programming ChartRain Bird Corporation9491 Ridgehaven Court, Suite C,San Diego, CA 92123, USAFor technical assistance contact Rain Bird at:1-800 RAINBIRD (1-800-724-6247) U.S. and CanadaVisit us on the web at www.rainbird.com