RANCH HAND1-800-366-9712INSTALLATION INSTRUCTIONS2017+ FORD F-250 | F-350 | F-450 | F-550PART # FSF201BL1 / FSF201BL1C / BSF201BL1Summit Front Bumper / Summit Bullnose Front BumperWarning: If your vehicle has adaptive cruise, please ensure that your adaptive cruise is working correctly once the Ranch Handbumper is installed. Adaptive cruise may need to be cleaned or adjusted to ensure it functions properly. See your owner’s manualfor care of the adaptive cruise.1. Unhook the fog light wiring harness.2. Remove the side bumper bracket bolts. Two on each side.3. If an Adaptive Cruise Control Module is present (located on the driver side) it will need to be unpluggedand removed. *Note: It will be installed later.4. Remove the factory bumper by removing the eight 18mm bolts. Four on each side.5. Remove the tow hooks. There are four 18mm bolts holding each tow hook.6. Note: Before installing the mounting plates, make sure the top of the frame rails and the bottom sides ofthe mounting plates are free of splatter. Slide the tow hook through the opening and mount the mountingplate over the frame. Use the tow hook bolt to install back to the frame. Use four ½” x 1 ¾” bolt, facingtowards the inside of the frame, to mount the mounting plate to the inside of the frame. TOW HOOKSMUST BE REINSTALLED!7. Make sure the holes of the tow hook bracket and the holes of the mounting plate line up.8. Mount the front bumper replacement to the mounting plates by using the ½” x 2” bolts.