EN INSTRUCTIONED-T43L-VIN20031 REV. A, 2020-10-28CCaauuttiioonn!! Read and understand the instruction before using the product.CCaauuttiioonn!! Ensure that the installation complies with local safetyregulations.CCaauuttiioonn!! Before installation or maintenance, the power supply should firstbe disconnected. Installation or maintenance of this unit should only becarried out by qualified personnel. The manufacturer is not responsiblefor any eventual damage or injury caused by inadequate skills during instal-lation, or through removal of or deactivation of any security devices.FunctionED-T43L-V is a user-friendly touch display suitable for all types ofindoor environments. The users have access to different settingsdepending on the assigned access rights.Technical DataGeneral dataSupply voltage 24 V DC (22…26 V DC)Power consumption 1.2 VAProtection class IP20Storage temperature -20…70 °CAmbient temperature 0…45 °CAmbient humidity 5…95 % rHDimensions, external (WxHxD) 144 x 96 x 14 mmDisplay type Resistive touchTouch panel 4.3" TFT-displayCommunication dataCommunication ports 1Port type RS485Default protocol ModbusSupported protocols ModbusCommunication speed 19200 bpsParity NStop bits 1InstallationThe display is starting up after connecting the power. Wait a few secondsfor the home screen to be shown.Log in as described under Handling.WiringThe display cable is connected to the display port on the Corrigocontroller via a 4P4C modular contact. The cable is ordered separatelyand is available in two versions (3 and 10 m). A user made cable can bemade according to the wiring diagram in Figure 1. The maximum cablelength is 100 m.Figure 1 User made cableSettingsThe display reflects the controller configuration. The configuration canbe changed with the free software Application tool (see www.regincontrols.com). Values such as setpoints, time channels, times etcare changed via the display as described under Handling.HandlingGetting started1. Press2. Log in with3. Go to Account settings and use the navigation buttons to go to page 34. Select the functions that should be shown in the display5. If a different language is required, navigate to page 2 and change itunder LanguageLog in access codeThe display uses the same access code that is used in the controller.NavigationNavigation is done using four main menu buttons.Menu button DescriptionThis is the home screen. Here the user gets an overview ofthe actual values and setpoints.In this menu fan settings are made:– Boost fan– Extended run– StopTime channels can be set and modified in this menu (if theyare configured in the controller).Different settings can be viewed or modified under this menu,e.g.:– Account settings, such as language settings and pin codes– Home screen content– Setpoints– Date and time– Status– Configurations related to CLOUDigo, TCP/IP and addressG0+CBA1234ED-T43L-V4P4C contactED-T43L-V 1