Reliance Foundry R-7539 Installation Manual

Reliance Foundry R-7539 Installation Manual Manual pdf 1 page image

Decorative Bollard Installation Adhesive Anchoring1-877-789-3245 | info@reliance-foundry.com | www.reliance-foundry.comTo protect the finish, keep bollards in originalpackaging until exact moment of installation.Handle with care to avoid scratching or damagingbollard surfaces as abrasions will lead to rust.Once scratched, bollards cannot be repairedto original form without re-finishing the entiresurface.Parts ListInstallation Equipment# PART QTY1 Bollard Base 12 Bollard Cap 13 Threaded Bar 1" 14 Washer 1" 15 Hex Nut 1" 16 Hexagon Socket Set Screw 37 Plastic Plug 31-1/8" Masonry Drill Bit Chalk1-1/2" Wrench Caulking Gun3/16" Hex Key LevelHammer Drill or Rotary Hammer Measuring TapeAdhesive Anchoring System* (included)Before InstallationSTEP 1: Always check for hazards such as water pipes,gas lines, and underground wiring before drilling.STEP 2: Use a broom or pressure washer to clean theconcrete surface prior to bollard installation.STEP 3: Study the site plans to locate and mark theprecise center point of each bollard. For secureinstallation, ensure there is a minimum radius** of solidconcrete around each mark.Drill the HoleSTEP 4: Tap a pilot divot hole in the center of each mark.STEP 5: Set the depth control on the hammer drill (orrotary hammer) to 4". If depth control is not available,mark 4" on the masonry bit.STEP 6: Drill a hole that has a 1-1/8" diameter and 4"depth. Drill on high speed, using the hammer functionif available.*Please refer to the adhesive manufacturer’s MSDS (included inshipment) before using.**Adhesive anchor manufacturers such as www.powers.comrecommend a minimum radius of 5".R-7539AC31245674" 1 1/8"

/ 2

Related manuals for Reliance Foundry R-7539