Saeco SUP 021 YDR Operating Instructions Manual

Also see for Incanto SUP021 YDR: Operating instructions

Saeco SUP 021 YDR Operating Instructions Manual Manual pdf 1 page image

6 8 9121.2.7- Clean nozzle with a needle(Attention: only proceed when machine isswitched off and tap is closed)1.11.21.21TSM SUCCESS MANUAL® - safe to use - easy tounderstand due to TSM® - Total Security Managementand ergonomic communication®T Y P E S U P 0 2 1 YD RObserve the display:ENERGY SAVINGDESCALINGFILL WATERTANKVENTILATECOFFEE BEANS EMPTYDREGDRAWER FULLBREWUNIT MISSINGDREGDRAWER MISSINGCLOSE DOORGRINDER BLOCKEDBREWUNIT BLOCKEDPush the «MENU/OK» buttonDescaling see respective section ; page 6Fill the tank with fresh waterVentilate (prime) the circuit (Starting)Fill coffee bean container with coffee beansEmpty the dregs drawer (with the machine switched on)Correctly insert the brewing unitCorrectly insert the dregs drawer and the drip trayClose the service doorGrinding motor is blockedThe motor of the brewing unit is blockedPlease call an authorized service centerclose ...open ...DESCALE Supplied accessoriesKey for brewing unitdismantling/assembly Cleaning brushCoffee measure Test strip for water hardnessTechnical data- Type SUP 021YDR- Nominal voltage See name plate under the coffee machine- Nominal output See name plate under the coffee machine- Supply See name plate under the coffee machine- Casing material Metal - plastic- Dimensions (L x W x H) approx. 27,5 x 35 x 42 cm / 11 x 14 x 17”- Weight (net) approx. 11 kg / 22 lbs- Length supply cable 1.2 m / 1.30 yards- Supply casing yes- Operating panel frontal- Water tank removable- Water tank capacity 1.8 l / 60 oz- Coffee bean container capacity 180 g / 60 oz beans- Heating Aluminium- Pump pressure 15 bar- Safety devices Security valve pump pressureSecurity thermostatTROUBLESHOOTINGNo displayNo power to the machine- Switch on main power switch- Check plug and connectionWith selection «Preground coffee»only water comes instead of coffee - Fill with a measuring dipper of ground coffeeCoffee is not hot enough - Activate the cup heater and puton the cups- Eventually clean the brewing unit,descaleNo hot water / steamHot water / steam nozzle is blockedHeating time is too longNot enough water - Descale machineBrewing unit cannot beremoved1. Close service door2. Switch on machine3. Brewing unit is unlocked4. Continue withBrewing unit cannot beinserted«Reset» brewing unitThe output does not startuse only a non-abrasive cleaning agentCLEANING- During cleaning the device must not be connected to the mains.- Do not dry any components in traditional or microwave ovens.Wipe with a soft damp clothCasingDregs drawerDrip tray Rinse under fresh waterWater tank - Rinse under fresh water- Extract the filter on the inside of the tankand clean carefully; insert the filter bylight pressure and rotative movementThis TSM SUCCESS MANUAL® has been examined by SEV for conformity with the safety-relevant standards, and has beenanalysed by an application-oriented risk analysis for the completeness and correctness of the indications for a safe use ofthe appliance. Thereby we assume a use with which can be reckoned based on common-sense.Clean weeklyNever clean in the dishwasherBrewing unit 1. Remove drip grid1.1 Open service door1.2 Remove dregs drawer anddrip tray2. Press PUSH position and remove unit.If necessary remove the upper filterof the brewing unitClean all the components underrunning warm water and dry carefully.Clean service area3. Reassemble brewing unit andpush in.DO NOT press PUSH position withthe brewing unit inserted.4. Insert drip tray and dregs drawerand close the service door2.1 Loosen sieve with key …2.2 … and remove2. Rinse under fresh water1. Extract external body by rotation anddownwards movementCoffee outletClean weeklyPlease read these TSM® operating instructions before operating the device. In order toobtain drinks of good quality and to avoid damage or injury, follow the instructionsprecisely. Ensure that these instructions are given to any other users of the device andthat they are kept in a safe place so that they can be referred to at any time. The devicehas been conscientiously checked for safety and correct operation. It left the factory infault-free working order.The enclosed «Safety Instructions» form an integral part of this user manual.Read «Safety Instructions» prior to initial operation of the device and keep it togetherwith the user manual.Operating InstructionsFill the water tank withthe descaling solution asinstructed by themanufacturer.Push for 3 sec.DESCALINGREADY FOR USEDESCALINGOPEN KNOBMACHINE IS RINSINGRINSING FINISHEDCLOSE KNOBObserve the display... ...and continue like follows:MACHINE IS DESCALINGOpen the knobDESCALING FINISHEDCLOSE KNOBRINSE MACHINEFILL WATERTANKClose the knobRinse the water tank and fill with 1 liter of fresh waterRINSE MACHINEPRESS KEY PushRINSE MACHINEOPEN KNOB Open the knobClose the knob and the descaling process is finished.MACHINE IS DESCALINGOPEN KNOB1.Close the knobDESCAL. INTERRUPTEDEMPTY WATERTANK2.Push3.Rinse and fill upthe water tankInterrupt the descaling2. Remove the internal mechanism3. Rinse all components of the nozzleunder fresh water in order to removemilk residues1. Extract external body byrotation and downwardsmovementPannarello4.Rinse machineEvery 3-4 months or whenthe message appears:- It is not permitted to draw off coffee, while descaler is in the water tank.- For descaling, the machine has to be connected to the mains and the main switchhas to be switched on.- For the descaling use a non-toxic and/or harmless descaler, available in common trading.- NEVER use vinegar, it could damage the machine!- Follow closely the manufacturer's instructions!- Should the descaling be interrupted by switching off the mains, it is absolutely necessaryto execute a complete cleaning cycle after restarting.- During the complete descaling process the machine interrupts, automatically and atregular intervals, the output of the descaling agent.PreparationPlace a big containerunder the hot water /steam nozzle.DescalingDuration: approx. 60 min.... the knobIf the descaling process is beinginterrupted, we suggest, to starta complete descaling cycle ata later date.DESCALINGREADY FOR USEcod. 1.6.589.19.02 Rev. 00 del 20/09/02

/ 2

Related manuals for Saeco Incanto SUP021 YDR