Armrest Bracket 1 5143-54Left Armrest 1 5144-02Bolt 4 5143-22Washer 4 5143-21Right Armrest 1 5144-03Screw, Phillips Pan Head 4 5143-27(for seats with PU (flat) bottom)Screw, Plastite 4 5143-28(for seats with PLASTIC (ribbed) bottom)5144-37MP: 1 of 3: 2/04 For questions or concerns, please call the Safco Consumer Hot Line 1-800-664-0042available Monday-Friday 8:00 AM to 4:30 PM (Central Time) (English-speaking operators)PRODUCT WARRANTY CARD is available online at: www.safcoproducts.comA SA SA SA SA S S E M B LS E M B LS E M B LS E M B LS E M B L YYYYY I N S T R U C T I O N SI N S T R U C T I O N SI N S T R U C T I O N SI N S T R U C T I O N SI N S T R U C T I O N SNew Hope, MN 55428Visit us on the web:www.safcoproducts.com5144Adjustable Armrest KitABCDEFGPART NO.PARTS LISTPARTS LISTPARTS LISTPARTS LISTPARTS LISTCODE DESCRIPTION QTY.Please note: Fasteners should be checkedperiodically and tightened as necessary.Thank you for purchasing this Safco product. Due tocontinual upgrading of our products, photographs orillustrations may not reflect the actual (exact) appearanceof product.Remove the two screws at the front of the control mecha-nism under the seat. IMPORTANT: save the screws forlater use.If you can slide the seat forward and up to release it fromthe control mechanism, do so; if not, remove the remainingtwo screws at the back of the control mechanism.IMPORTANT: save the screws for later use.Mount the A Armrest Bracket, with the notched side facingthe back of the seat bottom (straddling the seat plate ifthere is one). The armrest assembly comes with two typesof screws F or G ; match the screw to be used withscrews saved from Step 1 that fastened the control to theseat. Alternately tighten each screw until securely fas-tened. NOTE: if a pneumatic or electric screwdriver isused, make sure it is adjusted to not exceed 50 inch-pounds of torque at 90 PSI to reduce the chance of strip-ping the holes.Align the slot in the B Left Armrest with the holes in theraised portion of the armrest bracket, and attach withC Bolts and D Washers. Slide armrest to desired width,then tighten bolts securely. Repeat with E Right Armrest.Place the seat back onto the control mechanism; if the seathas a seat plate, slide the seat backward until the prongs ofthe seat plate engage the control mechanism. Align thetwo front holes of the control mechanism with the holes inthe seat, and use the two screws saved in Step 1. If youremoved two screws in Step 2, replace them now. Alter-nately tighten all screws until securely fastened.1234521354AREMOVE ANDSAVE SCREWSBECDORSCREWSREPLACE SCREWSORHOOK PRONGS INTOMECHANISMREPLACESCREWSF G(OR REMOVE ANDSAVE SCREWS)