Main: 713.896.6600Toll Free: 800.880.8855 www.safetyvision.com6100 W. Sam Houston Pkwy. N.Houston, TX 77041-5113Copyright © 2015 Safety Vision, LLC All Rights Reserved.830 SERIES QUICK INSTALLATION GUIDE GUIDEInstallation GuideThe customer should thoroughly read this guide beforeoperating this product.Safety Precautions• To reduce the risk of electrical shock, disconnect the batteryfrom the electrical system of the vehicle before starting theinstallation.• Before inserting fasteners into the mounting surface, ensurethat the underside of the mounting surface is clear ofequipment that might be damaged by the screws.Installation1. Use the selector switch located on the small printed circuitboard (PCB) to select if the red LED will blink or remain offwhen the camera receives power.2. Using the base as a template, tap or otherwise mark fourscrew holes in the desired mounting location.3. Drill a 0.875 inch hole in the approximate center of the fourmarked screw holes to thread the cables through.4. Thread the cables through the drilled hole and use self-tapping screws or rivets to secure the base to the desiredmounting location.5. Connect the cables to the MDVR unit.6. Loosen the security screws on the camera gimbal to adjustthe camera angle to the desired field of view. This mightrequire the use of an optional external monitor connected tothe MDVR unit. Once completed, tighten the security screwsin place.7. Connect the LED/Microphone cable in the enclosure to thePCB on the base.8. Secure the enclosure over the camera and base with thefour included tamper-resistant screws with a size T10 TORX™screwdriver.Notice to Users: This document is confidential and contains proprietary informa-tion belonging to Safety Vision, L.P. This document and the information containedherein cannot be distributed, communicated, reproduced, altered, or dissemi-nated by any means, in whole or in part, without the express written consent ofSafety Vision, L.P. Possession of this document constitutes the user’s acceptanceof these nondisclosure covenants. The information in this document is believedto be accurate in all respects. However, Safety Vision cannot assume responsibilityfor any consequences resulting from the use thereof. The information containedherein is subject to change without notice. Revisions or new editions to this publi-cation may be issued to incorporate such changes.Dome EnclosureWedge EnclosureThe SV-830 dome and wedge cameras are compact mobile-rated cameras that mount easily in a variety oforientations. High-intensity IRs and 420 TV lines of resolution allow for high quality images in multiple light conditions.Use the following procedure to install the SV-830 Series Day/Night Camera.