Sangoma 3050G Installation Manual

Also see for Vega 3050G: Hardware installation

Sangoma 3050G Installation Manual Manual pdf 1 page image

FIELD UPGRADEINSTALLATION MANUAL3050GFXO PLUG-INMODULE4. FXO MODULE ACTIVATIONThe following steps will guide you through the software process to activate the FXOports.A) Log into your Vega 3050G webGUI by typing its IP address inside the URL of abrowser of your choiceB) A window will pop up indicating there is a hardware change within the Vega.This message is normal as the FXO plug-in module was added.C) A factory reset of the Vega 3050G is required at this point to allow the unit tofully detect the new FXO ports. Click the 'factory reset' button visible near thebottom of the window (See Diagram below).A) A restore of your configuration is now required. Navigate to ‘System >Configuration and click Choose File where it says ‘Send File to Gateway’ . Awindow will pop up allowing you to search for the backup you previouslycreated (if you did not alter the name of the backup it will be called ‘config.txt’)B) Once selected click the ‘Upload’ button which will restore the Vega to previousconfigurationC) You will be required to Apply and Save settingsWith the Vega now ready, you may now configure the new FXO ports on your Vega3050G. Navigate to POTS and configure the ports.Sangoma.com © 2016 Sangoma Technologies Proprietary100 Renfrew Drive, Suite 100, Markham ON L3R 9R6 Canada+1 905 474 1990 or 1 800 388 2475 (toll free in N. America) sales@sangoma.com5. RESTORE YOUR CONFIGURATIONNote: Save yourexisting configuration ifyou have not done so,as described in Step 2.If you do not perform aback up, your existingconfiguration will belost.

/ 2

Related manuals for Sangoma Vega 3050G