Following checks and confirmations should be taken for safety.Check the following things by the time of the cabinet assembly after the lensreplacement.1. Check the lens is securely fixed.2. Check no parts is missing, or no mounting part is loose.LCD PROJECTOR LENSMODEL LNS-W32LENS REPLACEMENT PROCEDURENOTES ON LENS REPLACEMENTThe ZOOM, FOCUS and LENS SHIFT adjustment on the Top Control or theRemote Control cannot be operated with this Lens.Lens replacement should be performed by the qualified service personnel.It should be followed by this procedure precisely.Before attempt to replace the lens, confirm the model number (both the LCDprojector and the lens) and use the proper lens.The lens cover is on the lens for protection. Be sure to remove the lens coverbefore installation.When installing or removing the lens, be careful not to stain, scratch ordamage the lens.Following parts are contained in the packing.1AA6P1P3217A- (ICZAA-A)PARTS LIST● LENS● LIGHT-BLOCK SHEET BASE● DRIVER (3 mm, Green)● DRIVER (4 mm, Yellow)● LIGHT-BLOCK SHEET● SCREW1 piece1 piece (Part No. 610 310 8001)1 piece (Part No. 610 287 7328)1 piece (Part No. 610 275 6029)1 piece Type PC1 (Part No. 610 310 7967)1 piece Type PD1 (Part No. 610 294 3047)2 pieces (Spare parts)Some parts are not used for installation or replacement. Keep these parts anddrivers included in the lens for later use.NOTE; Lens installation is different in cabinet design and lens attachment method(Type A, B and C). Before installation the lens, check cabinet design andproper installation should be made.