Quick Start Guide(EN) Controls(1) STORE/LEVEL switches – Briefly flip the switchup to store the current loop as a backing track,or hold up for 3 seconds to delete stored backingtrack. Hold the switch in the down position whileturning the associated LOOP knob to adjust thelevel of the backing track.(2) LOOP knobs – Adjust the level of a loop orbacking track.(3) SERIAL/SYNC switch – When set to Serial, eitherloop 1 or 2 can be played at a time. In Sync mode,both loops can be played simultaneously.(4) DECAY knob – Controls the amount of volumereduction that occurs each time an overdub repeats.(5) FX knob – Selects one of the 7 FX options.(6) LOOP 1 and 2 footswitches – Use theseto control several loop-related functions.(see reverse side)(7) STOP footswitch – Press to stop both loopsimmediately. Hold to erase the loops.(8) FX footswitch – Press to engage the selectedloop FX.(9) INPUT jacks – Connect one ¼" TS cable for monooperation, or 2 cables for stereo.(10) OUTPUT jacks – Send audio via one or two¼" TS cables.(11) Power input – Connect the 9V power supply.(9 V DC, >300 mA)(12) MODE switches – Adjust fine details of pedal’soperation. See the full manual for details.(13) USB input – Connect to a computer to transferfiles back and forth, and for firmware updates.(14) MIDI jacks – Allows connection of an externalMIDI clock, and program and CC changes from aMIDI controller.IMPORTANT SAFETY INSTRUCTIONBefore operating the device, please see “ImportantSafety Instructions” on page 3 of the full manual.Visit tcelectronic.com to download the full manualDITTO X4 LOOPERSimple and Intuitive Dual-Track Guitar Looper Pedal with Powerful Loop Effects(1)(2) (3) (4) (5)(6) (7) (8)(9) (10) (11) (12) (13) (14)V 2.0