4. Check that the chair operates normally.3. Connect the power plug with the outlet.Installation Procedures1E04K4BE BOOK NO.1LANCER Installation ManualRubber ringBaseBaseFoot switches1. Move the chair to the installation location.Be sure to ground the chair to prevent accident due to current leakage and to improve the noise-dampeningperformance of the control circuit.Takara Belmont has no responsibility for any current leakage that results if the above-indicated procedures arenot performed.The chair must absolutely be grounded in order to prevent electric shock.Be sure to store this manual in a secure location together with the operation manual as it describesitems that must be understood by the customer.Move the chair by holding the skid.(Carrying the chair by the upper part is dangerousbecause the base could come off and drop.)Remove the chair from the skid. Raise thechair off the floor by holding the metal plateunder the foot switch. Move the chair byholding the base.2. Attach the rubber ring to the base.Determine the installation location. Lift the base off the floor and attach the rubber ring to the rim of the base.It is easier to attach the rubber ring by lifting up one side of the chair at a time. Hold the armrest and shoulderpart of the backrest to balance the force, and tilt the chair body to attach the rubber ring one side at a time.Do not apply excessive force to the armrest or other parts, or strike it from above when tilting the chair body.Prepare an available outlet * with an attached ground terminal.* 110 V, 120V, 220 V, 230 V, 240 V (7 A or more)Turn the power on and check that the chair raises/lowers normally, the backrest raises/reclines normally, thelegrest raises/lowers normally(AB-HPPN), and the rotation lock/release, preset feature, and auto-return featuresoperate normally.Bang