VOIP-600 Series PhoneRave Mobile Safety Integration GuidePage 1 of 4 Rev. 9/12/2014Copyright 2014 Talk-A-Phone Co. • 7530 North Natchez Avenue • Niles, Illinois 60714 • Phone 773.539.1100 • info@talkaphone.com • www.talkaphone.com.All prices and specifications are subject to change without notice. Talk-A-Phone, Scream Alert, WEBS and WEBS Contact are registered trademarks of Talk-A-Phone Co. All rights reserved.I. IntroductionThis guide provides general instructions for integration of the VOIP-600 Series Phone with a RaveMobile Safety account. Please read this instruction set completely before making any changes to thesystem. For detailed VOIP-600 Series Phone setup instructions, please consult the VOIP-600 SeriesPhone Manual.II. Prerequisites VOIP-600 Series Phone registered to receive direct inward dialing (DID) service calls andDTMF through a SIP proxy or registrar SIP proxy/registrar setup with direct inward dialing (DID) service Rave Mobile Safety account Network access to the Rave Mobile Safety account and VOIP-600 Series PhoneIII. VOIP-600 Configuration1. In the VOIP-600 main menu, select VOIP > Paging Settings.2. Enter the following fields on the Paging Settings page. Then click Apply.Select Paging Output:Choose Speaker if a standalone VOIP-600 or WEBS-PA-1Choose Line Level Output if a WEBS-CM-2, WEBS-PA-2IP, or connected to a WEBSTowerAdd gain to incoming page before sending to specified output:Output Gain: Range from 1-20, default setting is 20.Automatically activate paging for inbound Phone calls:Select No, as we need to use DTMF tones to be able to select specific devices.Key code to activate paging during an inbound call is:Select this check box and enter desired code.Key code to deactivate paging during an inbound call is:Select this check box if needed and enter desired code.