Get ConnectedWith FREE Ethernetfrom TallyGenicom2265/2280/2T+Serial Matrixto your network...

TallyGenicom 2265 Brochure

2265+

Hardware requirements

Printer at a glance

Installation

Placing your printer

Connecting the printer

Control panel

Changing the ribbon cassette

Paper handling

Changing the paper type

Single sheets

Paper transport

Settings

Technical data

Paper specifications

Introduction

About this manual

Printer in tractor mode

Paperway

Checking the printer voltage

Switching on the printer

Inserting the ribbon cassette

Printer drivers

Installing a printer driver in Windows 2000/2003/XP

Other operating systems

Changing printer settings

Loading optional firmware

The control panel

The LC display

Online mode

Setup mode

Messages in the LC display

Key functions when turning on the printer

Changing the paper type in the setup menu

Loading paper

Moving the paper to the tear position

Removing paper

Setting the tear position

Setting the first printing line (TOF)

Selecting character density and font

T model

Loading paper into the rear tractor

Paper guiding bracket

The Menu

Menu configurations

Menu handling

Selecting the LC display language

Terminating Setup mode

Menu structure

Menu parameters

Reset to default values (Reset)

Selecting font (Font)

Setting character density (CPI)

Skiping perforation (Skip)

Selecting emulation (Emulate)

Settings for interfaces (I/O)

Data format (Format)

Further Settings (Special)

Signal feedback (Remote)

Protocol (Protocol)

Selecting interface (Interf.)

Ethernet interface (ETH-INT)

Setting Subnet mask (Subnet)

IP address administration (IP Get M)

Selecting character set (CG-Tab)

National character set (Country)

Automatic carriage return (Auto-CR)

Menu lock (MenLock)

Paper parameters (Paper)

First printing position (FormAdj)

Printhead gap manually (Head)

View and tear position (AutoTear)

Line length (Width)

Normal characters and barcode (Barmode)

Form feed mode (FFmode)

Setting and activating options (PapOpt)

Activation of automatic sheet feeder (AutoASF)

Menu settings (example)

Advanced menu

Printer self-test (Rolling ASCII)

Exiting Rolling ASCII test mode

Interface test (Hex-Dump)

Terminating Hex-Dump

Advanced settings

Automatic paper motion sensor (PMS)

Form length (Forml)

Paper handling (Paphand)

Paper width (Pagewid)

Right-hand area (Rightzo)

Bidirectional parallel interface (CX-bid)

Beep at paper end (Sound)

Settings for paper with dark back (Pap.back)

Automatic paper width detection (APW)

Automatic detection of the top paper margin (AED)

Troubleshooting

General print problems

Problems with the paper feed

Paper jam (single sheets)

Problems with the print quality

Error messages via the display

2280

2T+ Series