©Tansun Limited 2013 Part No. 042220 Issue. 3cF o l l o w i n g i n f o r m a t i o n i s o n l y f o r E U - m e m b e r s t a t e s :The use of this symbol indicates that this product may not be treated as household waste. By ensuring this product is disposedof correctly, you will help prevent potential negative consequences for the environment and human health, which couldotherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of thisproduct, please contact your local council, your household waste disposal service or the shop where you purchased theproduct.Fig. T Fig. U7. Remove the screw (Fig. U) from the side reflector and lift it up away from the heater to remove it. Repeat at opposite end to remove other sidereflector.8. The emitter the wires should be pulled out of the side slots and the emitter can be lifted up completely (Fig. V). The wires should be gently pulled sothey come out from behind the reflector.9. The emitter should now be removed from the heater as shown in Fig. X.10. Refit the new emitter in reverse order ensuring that no wires get trapped and all screws are fully tightened.Fig. XFig. VReference ManualSorrento IPSingleUK & EUROPEAN MODELS:SOR 210IP, SOR 210IP UK, SOR 210IP EU,SOR 215IP, SOR 215IP UK, SOR 215IP EU,SOR 220IP, SOR 220IP UK, SOR 220IP EU.Spectrum House, Unit 1 Ridgacre Road,West Bromwich, West Midlands, B71 1BW, England.Tel: +44 (0)121 580 6200 - Fax: +44 (0)121 580 6222Email: quartzinfo@tansun.com - Website: www.tansun.com