Tapco ProTrax Installing
Also see for MaxTrax: Operating instructions
    |
Item # 11987T7924 1/10STEP 1Using the 1/4-20 bolts and lock washers provided, fasten the ProTrax/MaxTrax mounts to the Leg Set. Thesnap buttons will be on the working side of the brake. Repeat for the other Leg Set. Be sure both ends ofthe Snap Stand are going the same direction (with the snap buttons on the same side) See Figure 1 above.STEP 2Place the ProTrax/MaxTrax on theSnap Stand Assembly with the rearlip of the sub structure clearing therear clip. See Figure 2 above.snap buttons aretoward workingside of saw tablerear lipbypassingrear cliprear lipSTEP 3The snap button will becovered by the front substructure of the ProTrax/MaxTrax. See Figure 3 above.1. Removing the ProTrax /MaxTrax from the Snap Stand is essentially the opposite of attaching it to the stand.2. Depress the snap button and pull the saw table forward far enough to hold each snap button down.3. Be sure the lip on the rear sub structure is out of the Rear Clip. The ProTrax/MaxTrax can now be removedfrom the stand.4. Reverse Steps 1 and 2 on page 2 to disassemble the stand for transport.STEP 4Push the ProTrax/MaxTrax firmlyrearward into the rear clips. Thesnap buttons will pop up andsecure the saw table on the SnapStand. See Figure 4 above.S n a p S t a n dS n a p S t a n dInstalling a ProTrax ™ or MaxTrax™ Saw Table on Snap Stand®Removing the ProTrax or MaxTrax:Figure 1Figure 2 Figure 3 Figure 429797 Beck Road • Wixom, MI 48393-28343use these clipsuse these holes© Boral Building Products Inc. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine