PAGE 1 OF 12 0814 IH-3415π H-3415AUTO FOAMINGSOAP DISPENSER1-800-295-5510uline.comAPPLYING DISPENSER LABEL1. Peel label frombacking. Theadhesive is on theFRONT of the label.(See Figure 1)2. Open dispenser.Place label sticky sidedown on the INSIDE ofthe clear oval window.(See Figures 2-3)3. Close front ofdispenser.(See Figure 4)MOUNTING INSTRUCTIONSFor most applications, tape mounting is adequate.For porous, textured or wallpapered surfaces, screwmounting or a combination of screw and tapemounting is recommended.TAPE MOUNTING1. Important! Dispenser opensto the front. For idealplacement, the dispensershould be mounted 3"above any countertop,fixture or obstruction, and 2"below any cabinet, fixture orobstruction. (See Figure 5)2. Clean the mounting surfacethoroughly using any typeof general purpose cleanerand a paper towel.(See Figure 6)NOTE: Be certainsurface is completelydry before proceeding.3. Remove the protectivebacking from the tapepad on the back of thedispenser. Make certainthat the mounting surfaceis clean and dry. Carefullyposition the dispenser to thedesired location and pressfirmly to the surface for 30seconds. (See Figure 7)INSTALLATIONElectric DrillPhillips ScrewdriverTOOLS NEEDEDLabelFrontFigure 12"11" 7.5"3"Figure 5Figure 6Figure 7LabelFrontAdhesive SideDispenser DoorOpenedDispenser DoorOpenedFigure 2LabelBackFigure 3LabelFrontFigure 4Para Español, vea páginas 5-8.Pour le français, consulter les pages 9-12.