Ubiquiti airCube Router Config & Install Instructions(for Experienced Installers) v3.2Before Pugging in the Router:• Make sure you have the current airCube firmware on your laptop. (www.ui.com/download/accessories/aircube).• You’ll want these instructions open on your computer so you can copy UNMS key.Power Up Router:• Plug POE into airCube’s gray “24V POE In” port (NOT the blue port).• Alternately use a 5V micro USB.Plug/Connect Laptop to Router:• Connect laptop via Ethernet to port 2 or 3 on the airCube.• Alternatively, you can connect via Wi-Fi to the airCube -XXX Wi-Fi using the WPA2password printed on the bottom of the router–but be sure your computer is not seeingother Wi-Fi sources, they may hijack your config session.Open airCube Dashboard in Browser and Log In:• Open a browser and go to https://192.168.1.1• Advance through “connection is not private” warnings• Login with username “ubnt” and the “PSWD” printed on bottom of airCube (next to QRcode).Update Firmware:• Click “System” (gears icon) from black menu bar at left.• Under “Device Maintenance” select “Upgrade Firmware.” (Alternatively, you can selectthis from the top right of the main dashboard).• Select the firmware file from your computer, then proceed through the steps to Verifyand Upgrade it.• You will need to log back into the airCube after the upgrade completes—again using theusername “ubnt” and the “PSWD” on the bottom of the router.(continued on next page)