Page. 1Replacingthe UlticontrollerRepair manual Ultimaker 3Important: Make sure the filament is removed, the Ultimaker isturned off and the power supply is disconnected before you start thereplacement.Tip: All orientations are noted as seen from the front of the printerNote: These instructions are the same for the Ultimaker 3 andUltimaker 3 Extended.Tools• 2.0 hex screwdriver• Pliers• 0.3 Torque screwdriver with 11 CR-V socketParts• 1x 1994 - USB Ulticontroller boardReplacing the UlticontrollerEquipment/supplies neededFor internal use only