UnderCover SwingCase SC401D Installation Manual

UnderCover SwingCase SC401D Installation Manual Manual pdf 1 page image

Installation GuideSC401D - Drivers SideToyota Tacoma 2005-CurrentHardware Included1. Truck Bracket2. Self Drilling Screws (4)3. Striker Bracket12 3121. TRUCK BRACKET INSTALLATION -Remove the upper bolt from the ring thatattaches the factory tool box (T30 torx).Position the truck bracket into place andline up the hole in the truck bracket withthe hole for the torx bolt. Reinstall thetorx bolt, be sure the upper tab on thetruck bracket is tight against the vertical bed supportand tighten the bolt.Finish attaching the bracket using the four(4)supplied self drilling screws. Be careful not to overtighten and strip out the screw holes.2. STRIKER BRACKET INSTALLATION -Remove the two rear bolts from the ringthat attaches the factory tool box (T30torx). Install the striker bracket using thefactory torx bolts, use the two holes onthe right side of the bracket.DSC401D

/ 2

Related manuals for UnderCover SwingCase SC401D