Union Battery Service ZGL Series Installations, Maintenance And Mode Of Use
Pagina 1 di 2INSTALLATION, MAINTENANCE, AND MODE OF USE FOR ACID LEAD BATTERIES (revised 04.2016)1. Always install the batteries in well-ventilated environments.2. Install the batteries in environments with adequate temperature according to the batteries features (see thebattery technical file)WARNING: temperatures below 25°C make the capacity (autonomy) diminish, whiletemperatures above 25/30°C make the battery life diminish, consequently compromisingthe warranty.3. Connect in series only batteries of the same model (code), NEVER mixing new batteries with used ones. PAYATTENTION NOT TO ACCIDENTALLY CONNECT TWO POLES OF THE SAME BATTERY.4. When clamps are used for poles of battery type AP (conic), pay special attention to properly enlarge theabove mentioned clamps before inserting them on the poles. ABSOLUTELY AVOID using a hammer for theirapplication.5. Connect in series batteries using section cables adequate to the charge/discharge current and to the distancebetween the battery and the load. Eventually contact U.B.S. UNION BATTERY SERVICE.6. In case of connection in series, periodically alternate (once or twice a year, according to the use) the positionof all batteries (not to do for traction cells ZENITH CELLS).7. Always avoid the parallel connection. Eventually contact U.B.S. UNION BATTERY SERVICE.8. Carefully tight the poles screws, according to what follows:- M5 terminal: 5,9/6,1 Nm- M6 terminal: 11,9/12,1 Nm- M8 terminal: 22,5/23,2 Nm- M10 terminal: 24,5/27,0 NmEventual pole overheat due to an un-proper tighten is not cover by warrantee.9. IMMEDIATELY recharge after the discharge.10. Use battery chargers with adequate charge profile (see the technical files of batteries).11. In case of long periods of non-use, periodically recharge the batteries. High temperatures of storage requiremore frequent refreshing charges (ask U.B.S. for correct modes of refreshing charges).(ZL, ZNC, ZGL, ZPC, ZLS, CL) (ZTB, STARTER, CLASSIC, CELLS)Storage temperature 10°C to 20°C every 9 months every 3 monthsStorage temperature 20°C to 30°C every 6 months every 2 monthsStorage temperature 30°C to 40°C every 3 months every month12. Especially for batteries STARTER MOTORCYCLE, it is necessary to connect them to a charger, equipped withholding charge, if the use of batteries themselves is seasonal (generally in winter). Otherwise no warrantycan be applied.13. In STAND-BY application the use of cycles of charge with pulsating maintenance is recommended.14. Correctly size the batteries according to the discharge current (see the batteries technical file): wrong sizingmake the warranty immediately expire.15. Use the batteries ONLY for those applications compatible with their manufacturing features. See the tablebelow. Non compatible uses make the warranty immediately expire. The non exhaustive table below helpsthe understanding of correct application of different families of batteries: |
Related manuals for Union Battery Service CL Series
manualsdatabase
Your AI-powered manual search engine