Page 1/4ASSEMBLY AND INSTALLATIONINSTRUCTIONSWARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFFPOWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.T0384NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.2. Read and save these instructions.Features1. Energy saving fixture.2. Use the dim-to-bright illumination option whereyou want some minimum illumination through outthe night, such as at your front entrance or garagedoor. Use the dark-to-bright illumination optionwhere you do not need minimum brightness, suchas the backyard or back porch.3. When in manual override mode, use wall switchto keep the light ON till dawn.180112Mounting Screw (B) Green GroundingScrew (C)Lock Nut (E) Wire Connector (F) Ball Nut (G) Rubber Pad (H)Cross Bar (A)Important to Know1. Read all instructions carefully before installation and operation.2. If you are not familiar with state and local electrical codes, it isrecommended that you consult with a qualified electrician.3. Before installation, shut off power at the main fuse or circuitbreaker box. Be aware that simply turning off the wall switch isnot sufficient to prevent an electrical shock.4. This fixture requires a 120 VAC, 60 Hz power source.5. Do not attempt to take the lantern apart; there are noserviceable parts inside.6. To avoid sensor damage by lightning or electrical surge, makesure the grounding wire is securely connected.7. For general safety and to avoid any possible damage to thesensor, be sure the power is switched "off" before replacing thebulb.8. Compatible with LED dimmable bulb.Maximum Wattage: 60W Incandescent Bulb or 20W LEDdimmable bulb.Work Temperature: -4°F~104°FHardware Package (included)Green Grounding Screw (C)Outlet BoxWire Connector (F)Fixture Mounting Screw (D)Cross Bar (A)Lock Nut (E)House Grounding WireFixture Grounding WireFixture WireBulb Type T MAX 60W(not included)Mounting Screw (B)FixtureBack PlateBall Nut(G)Rubber Pad(H)Fixture MountingScrew (D)