ASSEMBLY AND INSTALLATIONINSTRUCTIONS181029NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.2. READ AND SAVE THESE INSTRUCTIONS.T0451 / T0455Lock Nut (E)Mounting Screw (B) Wire Connector (F) Ball Nut (G) Rubber Pad (H)Cross Bar (A) Green GroundingScrew (C)Headless Screw (D)WARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFFPOWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.Hardware Package (included):Turn off the power at fuse or circuit boxInstallation Steps1. Thread two headless screws (D) through the cross bar (A), and then securethem with four lock nuts (E). Adjust the length of the headless screws (D)if necessary.Note: Make sure that the headless screws are lined up horizontally tomake the fixture level.2. Attach the cross bar (A) to the outlet box by using two mounting screws (B).3. Pull out the source wires from the outlet box. Make wire connections usingwire connectors (F) as follows:---Connect the hot wire (usually black insulation) from the fixture to the blackwire from the power source.---Connect the neutral wire (usually white insulation) from the fixture to thewhite wire from the power source.---Attach the fixture grounding wire (usually green insulation or bare wire) tothe cross bar with the green grounding screw (C), and then connect it tothe house grounding wire with the wire connector (F).Carefully put the wires back into the outlet box.Ball Nut (G)Replacement Ball NutBulb Type AMax. 60W(not included)GlassRubber Pad (H)Wire Connector (F)Outlet BoxLock Nut (E)Mounting Screw (B)Fixture WireGreen Grounding Screw (C)Cross Bar (A)Fixture Grounding WireFixtureHeadless Screw (D)Back Plate