ASSEMBLY AND INSTALLATIONINSTRUCTIONS1906111. Unscrew the four set screws (C) from the cover.2. Install a bulb (not included).See relamping label at socket area or packagingfor maximum allowed wattage.3. Alight the holes on the lamp frame to the fixture’s,secure them by threading the set screws (C) goingthrough the holes one by one.4. Pull out the wires and grounding wire from the post.Make wire connections using the wire connectors (B):---The hot wire (usually black insulation) from thefixture to the black wire from the post.---The neutral wire (usually white insulation) fromthe fixture to the white wire from the post.---The grounding wire (usually green insulation orbare wire from the fixture to the grounding wirefrom the post.Carefully put the wires back into the post.5. Place the fitter on the top of the post, and thensecure it with three fitter screws (A).NOTE: With silicone caulking compound,caulk completely around where the fittermeets with the post surface to prevent waterfrom seeping into the post.NOTES: 1. Before installing, consult local electrical codes for wiring and grounding requirements.2. READ AND SAVE THESE INSTRUCTIONS.T0521 T0526Hardware Package (included):Fitter Screw (A) Wire Connector (B)Turn off the power at fuse or circuit boxInstallation StepsWARNING: TO AVOID RISK OF ELECTRICAL SHOCK, BE SURE TO SHUT OFFPOWER BEFORE INSTALLING OR SERVICING THIS FIXTURE.Turn on the power at fuse or circuit boxCoverSet ScrewLamp FrameFitterFitter Screw (A)Wire Connector (B)Grounding WirePostBulb Type A MAX 60W(not included)