Mobile GeneratorG 150G 180G 240OPERATOR’S MANUAL0171953en 00307090 1 7 1 9 5 3 E N

Wacker Neuson G 150 Operator's Manual

G 240

Foreword

Safety Information

Machine Description and Intended Use

Safety Guidelines for Operating the Machine

Service Safety

Operator Safety while Using Internal Combustion Engines

Safety Guidelines for Mobile Generators

Safety Guidelines for Towing the Machine

Safety Guidelines for Lifting the Machine

Label Locations

Label Meanings

Lifting and Transporting

Before Towing Checklist

Towing the Machine

Preparing the Machine for Transport on a Truck or Trailer

Hazardous Materials Placards

Testing the Breakaway System (Hydraulic Surge Brakes)

Testing the Breakaway System (Electric Brakes)

Machine Setup

Positioning the Machine

Grounding the Generator

Recommended Fuel

Refueling the Machine (Basler Controller)

Refueling the Machine (Deep Sea Controller)

Operation, Control, and Component Locations

Operation (Basler Controller)

Engine Start Switch

Genset Pre-Alarms and Alarms (Shut-Down Conditions)

Overcurrent Condition

Diesel Particulate Filter (DPF)

Using the Lugs and the Convenience Receptacles

Selecting the Voltage

Before Starting the Machine

Starting and Running the Generator

Stopping the Machine

LCD Panel: Monitoring Machine Operation

Working with Basler Controller

Menu Diagram of the Genset Controller

Menu Diagram Components

Using the Metering and Settings Menus

Logging in to the Genset Controller by Entering the Password

Adjusting the LCD Screen Contrast

Changing the Time/Date Settings

Changing the Sender Fail Time Delays

Changing the Units of Measure

Changing the Low Fuel Pre-Alarm Setting

Changing or Disabling the Low Fuel Alarm Setting

Changing the Cooldown Time Setting

Changing the Pre-Crank Time Delay (Glow Plug Timer)

Changing the Maintenance Interval

Resetting the Maintenance Interval Pre-Alarm

Resetting a Loss of Voltage Pre-Alarm

Accessing and Using the Event Log

Operation (Deep Sea Controller)

Genset Controller Power Switch

Deep Sea Controller Buttons/Functions

Genset Controller Alarms and Shut-Down Conditions

Stopping the Generator

Emergency Stop Switch

Engine and Generator Monitoring

Working with Deep Sea Controller: DSE 7310

Navigating the Menus

Adjusting Screen Contrast

How to Reset the Maintenance Timer

How to Connect Loads

Best Practices for Balancing Loads

Connecting 480V, 3-Phase and Single-Phase Loads

Connecting a 240V 3Ø Load and a 240V 1Ø Load

Connecting a 220–240V 3Ø Load and Multiple 127–133V 1Ø Loads

Connecting a 208V 3Ø Load and Multiple 120V 1Ø Loads

Using Remote Start Capabilities

Remote Transfer Switch

Preparing for Automatic/Remote Start-Up (Basler)

Preparing for Automatic/Remote Start-Up (Deep Sea)

Diagnostic Trouble Codes (DTC)

Accessing Engine DTCs using the Deep Sea Controller

List of Engine Diagnostic Trouble Codes (DTCs)

Factory-Installed Options

Lockable Battery Disconnect

Camlocks

Containment System

Engine Block Heater

Low Coolant Shutdown

Temperature-Activated Shutters

Positive Air Shutoff Valve

Quick-Disconnect Fuel Fittings

Lube Level Maintainer

Machines with Aftertreatment Exhaust System

Filling the DEF Tank

Shelf Life of Diesel Exhaust Fluid (DEF)

Monitoring and Control of the DEF Level

G 150

G 180