2. Remove the screw, washer and top plate from the M10 Hand Knob m , then connect the M10 HandKnob m and C-clamp b with the screw, washer and top plate that were just removed.Select the preferred height according to your desk thickness. Connect C-clamp b to C-clamp Brace cusing M8x12 Bolt g , and tighten with Allen Key 5mm i . Rotate the Hand Knob m clockwise to fastenfor stability.M00LP/M00LP-WLaptop Tray Desk Mount75x75\100x100INSTALLATION MANUAL1-844-SATTLER (18447288537)support@walielectric.comwww.walielectric.com(10kg/22lbs)RATEDWARNINGUSE OF TIPOVER RESTRAINTS MAY ONLY REDUCE, BUT NOT ELIMINATE RISK OF TIP OVER.SMALL PARTS- NOT FOR CHILDREN UNDER 3 YEARS. ADULT SUPERVISION IS REQUIRED.If you do not understand these directions, or if you have any doubts about the safety of the installation, please call aqualified technician. Check carefully to make sure there are no missing or defective parts. Improper installation maycause damage or serious injury. Do not use this product for any purpose that is not explicitly specified in this manual.Do not exceed weight capacity. We cannot be liable for damage or injury caused by improper mounting, incorrectassembly or inappropriate use.SERIOUS OR FATAL CRUSHING INJURIES CAN OCCUR FROM TIPOVER. TO HELP PREVENT TIPOVER:TIPOVER WARNINGSupplied Parts ListLaptop : 17'' MaxMonitor27'' MaxOption A : Clamp Installation1. Connect Pole a and C-Clamp Brace c from the bottom using M5x14 Bolt f andtighten with Allen Key 3mm o .Option B : Grommet Base Installation1. Place Pole a onto Grommet Base Plate m . Connect them from the bottom using M5x14 Boltand tighten with Allen Key 3mm .aiiiiifoccc cca faaqqqnqff1Stick the EVA pad B tothe C-Clamp Brace co3mmWire Clipl (x2)Wire Clipk (x1)Grommet Base Plateq (x1)Support Platep (x1)M10 Hand Knobm (x1)EVA Pad An (x1)EVA Pad Bo (x1)Polea (x1)VESA Platee (x1)M5x14 Boltf (x3)M4x12 Boltj (x4)Swivel Armd (x1)Anti-skid Padu (x4)M4x12 Bolts (x4)Laptop Trayr (x1)D4 Nutt (x4)C-Clampb (x1)C-Clamp Bracec (x1)mmmbi mStick the EVA pad A o tothe Grommet Base Platenv (x1)WrenchbggbcM6 Nuth (x1)M8x12 Boltg (x2)Allen Keyi (x1)m b