Watermark WM-BTMIC07 Quick Manual
  |
REV.:001 08/2017FFQuick Guide Bluetooth Music Receiver WM-BTMIC07 Variante 1Compatible with the following models: AUDI: CQ-JV1060L, RNS-E (16:9), BNS 5.0, Chorus 3, Concert 3, Symphony 3 VW: MCD, MFD2-RNS 2, MFD2 DVD-RNS2 DVD, R110, R100, RNS 300, RNS 500, RNS510, RCD 200, RCD 210, RCD 300, RCD 310, RCD 500, RCD 510, Delta 6 SKODA: Nexus (16:9), Columbus, Stream, Cruise, Rhapsody SEAT: Navigation (16:9), Audiosystem CD03, Altea CD01, Altea CD02Connect the adapter:1. Remove the radio.2. Before disconnecting the plugs from the radio, make sure that the radio code is available to you,as you will need it for the radio after the power interruption.3. Insert the plug of the Bluetooth adapter WM-BTMIC07 from the backside of the Quadlock pluginto chamber B until it clicks into place. This should also work if the Quadlock plug is stillplugged into the radio (but switch off the radio before plugging it in). If the cables are short oryou can't see the connectors on the back, you can disconnect the Quadlock connectorcompletely from the radio.4. Now connect the black ground cable with the ring eye either to the radio housing or the blackcable directly to a ground cable to the Quadlock plug. Without a good ground connection thefunction of the adapter is not given.5. Now connect the cable with the 3.5mm jack plug, which goes into the white beech, to the jacksocket SPK.6. Position the microphone near the driver in the vehicle (steering wheel fairing, dashboard, etc.).The cable is then routed to the Bluetooth adapter and connected to the microphone inputlabeled MIC. Avoid placing the microphone in the immediate vicinity of or on airbags.7. Before you reinstall the radio, test the function of the adapter. Use the CD changer button toswitch to the external CD changer (CDC).8. Before you reinstall the radio, test the function of the adapter. Use the CD changer button toswitch to the external CD changer (CDC).9. Optionally, a push button can be connected to the two open cables to accept and terminatecalls (a commercially available push button can be used for this purpose). Without a pushbutton, the call is accepted and ended via the connected telephone.Anything unclear? You reach us MO-FR, from 8-17 o'clock by e-mail: service@watermark-germany.deREV.:001 08/2017FF |
Related manuals for Watermark WM-BTMIC07
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine