Woodford 22 Installation Instructions Manual
Also see for 22: Troubleshooting & MaintenanceTroubleshooting & MaintenanceInstallation instructions
  |
For more information contact…WOODFORD MANUFACTURING COMPANY2121 Waynoka Road, Colorado Springs, Colorado 80915 • Phone: (800) 621-6032 • Fax: (800) 765-4115To view our complete product line visit: www.woodfordmfg.com or email: sales@woodfordmfg.comA Division of WCM Industries, Inc.Model 22 & V22HOT & COLDFreezeless Wall FaucetRev 06/10 Form No. II22.101NOTE: The packing nut, located behind thehandle, has been factory adjusted. If leakageshould occur after installation or use, thepacking nut can be tightened to stop the leak.FIGURE 2Model 22Anti-siphon protectedFIGURE 1-225” TubeCentersFastenersNozzle2 1/4” TubeCentersNozzleFastenersDownward Pitch(2) 1-1/8” Dia. HolesPacking NutFIGURE 2-22Model V22Anti-siphon protectedFIGURE 1-V22 FIGURE 2-V22Packing Nut DownwardPitchWall faucets must be properly installed andoperated to insure drainage. Improperlyinstalled or operated wall faucets may freezeand burst in freezing weather.INSTALLATION INSTRUCTIONS:1. Before installation, flush supply line toremove any debris.2. Drill (2) 1-1/8” diameter holes through thewall in the desired location and insert thefaucet from the outside. FIGURE 1a. Drill (2) holes for the horizontalmounted Model 22 water tubes on5” centers.b. Drill (2) holes for the verticalmounted Model V22 water tubes on3 ¼” centers.3. Install faucet with nozzle pointing down.FIGURE 14. The water tubes must have a slightdownward pitch for proper drainage.Proper drain angle is built in to the faucethead if mounted on a vertical surface.FIGURE 25. Secure faucet to the wall usingappropriate fasteners installed through theholes in the flange. FIGURE 16. For a solder connection inlet, open faucetto full open position before soldering.Excessive heat can damage valve seatrubber or stainless steel seat and factorysolder joint. |
Related manuals for Woodford 22
manualsdatabase
Your AI-powered manual search engine