INSTALLATION INSTRUCTIONSMODELML85Micro Link™ Peep-Hole StylePlasma\LCD\LED\CFL FriendlyIR Receiver1DESCRIPTIONThe Micro Link IR Receiver is a small peep-hole style infrared repeaterassembly. The Micro Link IR Receiver is equipped with a 7-foot cable anda 3.5mm stereo mini plug, which is plugged directly into the “IR RCVR”jack on the connecting block, such as the models 789-44, CB60, and 791-44. The Micro Link IR Receiver is primarily intended for use in installationswhere the connecting block is within reach of its 7-foot cable – as wheninstalling the Micro Link IR Receiver in a cabinet where the controlledequipment is behind closed doors.FEATURES• Small size; mounts in 1/2” diameter hole. 2 inches deep (50mm).• Quick-Connect 3.5mm Stereo Mini Plug on 7ft. cable for direct plug-into Xantech Connecting Blocks.• Works in normal 3-wire mode (12VDC, IR, GND).• Green Talkback LED for System Verification.SPECIFICATIONS• Infrared modulation frequency bandwidth: 30 – 60 kHz.• IR reception range: Up to 80 feet, depending on remote control outputstrength and ambient conditions.• Reception angle: 55 degrees off axis for 50% range reduction.• Cable requirements: 3-conductor. Use 24 gauge up to 200’, 22 gaugeup to 600’ 20 gauge up to 2000’, 18 gauge up to 5000’ – unshieldedOK.• Max. transmission length: 1 mile using 18 gauge wire.• Maximum current output: 100mA• Drives IR emitters through Xantech Connecting Blocks, Controllers,etc.• Dimensions: 1/2” diameter x 2” deep (13mm x 50mm).• Power requirements: +12VDC, 20mA.