FFRROONNTTIIEERR XXBBBB2200--FFTT330000 AANNTTII--SSCCAALLEE SSYYSSTTEEMM WWIITTHH SSPPEECCTTRRUUMM UUVV SSYYSSTTEEMMIINNSSTTAALLLLAATTIIOONN MMAANNUUAALL1.0 BEFORE INSTALLATIONCongratulations you have bought one of the most environmentally friendly scale prevention systems. This system does notwaste any water, uses no electricity, no salt and no electrical valve is required. It basically converts the calcite in water intoharmless crystals which minimises scale formation. Please read through all the instructions carefully before proceeding withthe installation. Be sure to follow any special plumbing codes in your area. You can also contact your local dealer if you arehaving problems installing it. Diagram 1 illustrates the plumbing connections that are needed to install the system.Please make sure that the XBB20-FT-300 system is not directly exposed to the sun. The ultra violet from the sun can causedamage to the plastic housings.CAUTION: DO NOT USE WITH WATER THAT IS MICROBIOLOGICALLY UNSAFE OR WITH WATER OF UNKNOWNQUALITY WITHOUT ADEQUATE DISINFECTION BEFORE OR AFTER THE SYSTEM. SYSTEM CERTIFIED FOR CYSTRECDUCTION MAY BE USED ON DISINFECTED WATER THAT MAY CONTAIN FILTERABLE CYSTS. PLEASE HAVETHE SYSTEM SERVICED REGULARY, PREFERABLY EVERY 6 MONTHS.2.0 SYSTEM COMPONENTS1. Outlet fittings: 3/4” male x 1”male brass adapter.2. 3 stage big blue housingsystem with stainless steelbracket.3. Wall mount Spectrum UVsystemDiagram 13.0 MOUNTING THE FRONTIER XBB20-FT-300There are two types of Frontier XBB20- FT-300 anti-scale systems. The first system is wall mounted and the second has astainless steel stand. However, they both use the same type of cartridges. The system comes with 2 x ¾” male to 1” malebrass fittings. XBB20-FT300SS does not need any mounting. Go to section 4 if you have this system.3.1 XBB20-FT300 Mounting instructions.The mounting bracket has been packed upside down in the original packaging. The mounting bracket will need to beunscrewed and turned the right way up before installation. The bracket is fully marked with the order of each cartridge type.The cartridge is already inside the housings. Please ensure that the housings are placed in the correct order to preventincorrect installation.