YOW! CraftY Cutter Quick Start Manual
  |
Quick Start GuideThe blade tip recommends leaking a length of about 0.2 mm,but new users tend to use too longer blade tip.Our idea is to cut only the surface of the sticker,but leaving only the minimum scratches under the bottom.This way you can easily tear off the adhesive. If you can't cutthrough a small corner or some small details, you canincrease the length of the blade.The recommended speed setting is 600 mm / sThe blade force setting 10 - 20.1. Verify the Package ContentsPowercable portBlade carriage(Built-in Camera)Touch screencontrol panelSet the blade tip toonly the surface ofthe material withoutcutting the bottom layerBlade holder 1 pcs60 degree blade 1 pcs45 degree blade 2pcsPen tool 1 pcsUSB Cable 1 pcsCutting Mat 1 pcsPower adaptor 1 set2. Note the Names of PartsU-diskinterfaceUSBcableportBlade holder seat:Tightener for LockingBlade HolderPower button:Click for power on,Hold on 3 seconds for power off.Pinch wheels assembly lever：Up for pressing material, downfor release materialPinch wheels assemblypressure lever：Up for higher force pressing,down for normal force.3. Blade installing instructionThe most commonly used 45-degree case (red cap)Thin material uses a 60-degree knee (blue cap)4. Blade tip and blade force / speed value recommended settings1) Press the silverbutton to eject the blade3)The tip length can be adjusted by turning the gold knobcounterclockwise5)Turn the gold knob clockwise to fix the tip length4)Adjust the length ofthe tip of the tool holderby turning the silver knob2) The blade can be insertedhere, be careful that the tipof the blade can easily hurt you.5. Place materialStep 1. Pull down the pinch wheelsassembly lever.Step 2. Move the pinch wheel assembly again the steel axis.Step 3. Load the material, at least 2 pcs pinch wheels pressing the material.Step 4. Pull up the pinch wheels assembly lever, make sure material holding well.Step 5. The blade is the origin point for cutting, move the blade carriage to specifyposition and then start cutting.Step 6. If it is print and cut job, need to move the blade tip around 3mm close to thefirst mark.First Mark |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine