Before commencing installation check that all parts areworking correctly.• Exterior Code Pad Assembly: Enter code from thepre-set factory code card, and turn the knob to the right.The knob should turn and return freely under springpressure. IF YOU INTEND TO CHANGE THE CODEYOU SHOULD DO IT NOW. Refer to code changinginstructions.• Interior Handle Assembly: Make sure that the leverhandle turns freely.New Installation:1) Check the hand of your doorViewed from the outsidedoor is left handed if thehinges are on the right.Push button door lock (Model P-DL01 and2) Apply the templateSelect the desired position on thedoor. Fold the template along thedotted 60mm line and tape to thedoor.• Mark and drill all six 10mm holes as shown on the template.• Mark the central point on the "centre line of latch" on theedge of the door and drill a 25mm hole to a depth of 95mmfor the latchbolt.• Use a chisel to clear the line of 4 x10mm holes into asingle slot.• Insert the latchbolt into the the edge of the door and markaround the face plate.• Remove the latchbolt and cut a 3mm rebate so that the faceplate fits flush with the edge of the door.• Fit the latchbolt with 2 wood screws.(Ensure thatthe bevelled face of the latchbolt faces the door frame)• Latchbolt: Check that the spring latch andmove freely.OUTSIDEINSIDELEFT HAND RIGHT HAND(Code Pad side) your1. 2. 3.6. 8. 9. 10.11. 13.2. Interior Handle Assembly1. Exterior Code Pad Assembly3. Neoprene Seals. x 25. Spindles x 3 (only one is used)4. Latchbolt (60mm standard)6. Interior handle assembly fixing bolts(2 x 50mm)(2 x 36mm)7. Wood Screws x 4. Use withLatchbolt and Strike plate8. Latchbolt Support Post9. Spare Colour Code Tumblers x 410. Tweezers11. Strike Plate12. Strike Box13. Code Card12.7.pre-set code hereRecord your factoryCYX543Z09821 674. 5.x2 x214. Exterior Code Pad Fixing lugs x 214.spindle hubPack ContentsFitting InstructionsIssue No: 01-2012Push Button Door LockFitting InstructionsThe world’s favourite lock since 1843School Street, Willenhall, West Midlands WV13 3PWwww.yale.co.uk Tel: +44 (0) 1902 364647 E-mail: info@yale.co.ukTools RequiredCross HeadScrewdriverDrill RequiredDrill Bits:Ø10mmØ25mm