Yale® Z-Wave Plus™ Smart ModuleInstallation GuideP/N AYR-MOD-ZW3-MNL-0015 Rev A®Removing a Yale Z-Wave Plus™ v2 Smart Module from your Assure Lock & Z-Wave™ System4. On your lock keypad, enter your master entry code followed by the icon6. Press the 1 key followed by the icon5. Press the 7 key followed by the icon1. Install Yale Smart Module into slot above battery compartmentIMPORTANT: Batteries must be removed before inserting Yale Smart Module:• Remove battery cover• Remove batteries• Insert Yale Smart Module• Reinstall batteries• Reinstall battery cover2. Open Z-Wave™ system's smart home or alarm app on your smartphone or tablet3. If you have SmartStart* enabled with your Z-Wave™ System follow in-app prompts to add anew device If you don't have SmartStart or are not sure, follow steps 4 - 6Please use this procedure only when network primary controller ismissing or otherwise inoperable.Adding a Yale Z-Wave Plus™ v2 Smart Module to your Assure Lock & Z-Wave™ SystemIf prompted, scan QR code1. Open Z-Wave™ system's smart home or alarm app and follow instructions for removing a device2. On your lock keypad, enter your master entry code followed by the icon3. Press the 7 key followed by the icon4. Press the 3 key followed by the icon5. Remove Yale Smart Module from slot above battery compartmentIMPORTANT: Batteries must be removed before removing Yale Smart Module:• Remove battery cover• Remove batteries• Remove Yale Smart Module• Reinstall batteries• Reinstall battery cover6. If you're adding a new Yale Smart Module, follow instructions included with it*SmartStart enabled products can be added into a Z-Wave network by scanning the Z-Wave QR Code present on the product with acontroller providing SmartStart inclusion. No further action is required and the SmartStart product will be added automatically within 10minutes of being switched on in network vicinity.