Yealink SIP-T22 Quick Installation Manual

Also see for SIP-T22: Owner's manual Quick installation guide User guide Administrator's guide Quick start guide

Yealink SIP-T22 Quick Installation Manual Manual pdf 1 page image

Click on -> -> (X=1,2,3)www.yealink.comPlease locate your computer in the same network segment of the IP phone (192.168.0.X) to access theweb user interface. Contact your system administrator for more information.Check with your system administrator if any error appears during the registration process or a specificconfiguration is required for your registration.The wrong network settings may result in inaccessibility of your phone and may have an impact on thenetwork performance. Contact your system administrator for more information.1. Press the key when the phone is idle to get the IP address of the phone.You can configure the network in the following ways:It shows the register status of the current account.You can select Enabled/Disabled to enable/disable the account.It is shown on the LCD to identify the account.It is shown as caller ID when placing a call.It is provided by ITSP for registration (required).It is an authenticated ID for authentication provided by ITSP (required).It is provided by ITSP for registration (required).It is provided by ITSP for registration (required).: By default, the phone attempts to contact a DHCP server in your network to obtain its validnetwork settings, e.g., IP address, subnet mask, gateway address and DNS address.: If your phone cannot contact a DHCP server for any reason, you need toconfigure IP address, subnet mask, gateway address, primary DNS address andsecondary DNS address for the phone manually.: If you are using an xDSL modem, you can connect your phone to the Internet via PPPoEmode. Contact the ITSP for the PPPoE user name and password.Press the soft key when the phone is idle, select -> ( )-> -> to configure the network.For more information, refer to the User Guide available online:Copyright 2014 YEALINK NETWORK TECHNOLOGY CO.,LTD.Press the soft key when the phone is idle, select -> ( )-> to configure the account.2. Open the web browser on your computer, enter the IP address into the address bar (e.g.,"http://192.168.0.10" or "192.168.0.10") and press .Register Status:Line Active:Label:Display Name:User Name:Register Name:Password:Server Host:3. Enter the user name (default: admin) and password (default: admin) in the login pageand click .Click on -> ->For more information on account parameters, refer to .Registered Register Failed RegisteringcApplies to firmware version 72.1 or later.Applies to firmware version 72.25 or lateApplies to firmware version 72.1 or later.All manuals and user guides at all-guides.comall-guides.com

/ 2

Related manuals for Yealink SIP-T22