Yealink BYOD Guide - bwvoip550 W. Adams St., Suite 900, Chicago, IL 60661+1 (866) 629-8200, Option 4info@inteliquent.comInteliquent, We empower communications help.inteliquent.comYealink® Bring Your Own (BYOD) Device Guide for DECTIf you already have Yealink DECT devices, they may be compatible with the Inteliquent solution. For Yealink, Inteliquentcurrently accepts the models listed in the table below. If you already have one of these devices, just follow the instructions toincorporate it into your service.Supported Yealink ModelsW76PBefore You BeginIn order to configure your devices, specific information is needed. At the time you place your Inteliquent order, pleaseprovide a MAC address for each Yealink device. (The MAC address is listed on the bottom or back of the device).Repointing and Activating Yealink DevicesTo begin, you will need to factory reset and repoint the devices to the Inteliquent service. Follow the instructions below.1) Reset the device to factory default settings.a) Using one of the handsets, press OK, then navigate to the Settings icon and press OK.b) Scroll down to the System Settings option using the down arrow navigation key and press OK.c) Scroll down to the Base Reset option and press OK.d) Enter the current PIN and press OK. If you don’t know the base PIN, try “0000” which is the default PIN. Contactsupport@voyant.com if you don’t know the PIN and the default doesn’t work.e) The phone will prompt “Reset to factory setting”. Press OK, then press Yes to reset the base to factory settings.f) Allow the phone to reset and return to factory settings.2) Capture the phone’s IP address.a) Using one of the handsets, press OK, then navigate to the Status icon and press OK.b) Choose Base and press OK.c) Write down the numbers as shown in the IPv4: row __________________3) Log into the device.a) Using a computer on the same local network, use a web browser to navigate to the IPv4 address you noted above instep 2 using https.i) Example: Enter https://192.168.0.2 in your browser’s address bar.b) On the login screen, enter the default username (admin) and password (admin) and click Login.4) Configuring Provisioning Server Information.a) Once logged in, do the following:i) On the left menu bar, click on the Settings menu. The menu will expand.ii) Click Auto Provision from the list.iii) In the Auto Provision settings, set PNP Active to Off and set DHCP Active to Off.iv) In the Server URL field, enter https://xsp.bwvoip.net/dms/Yealink_W70B and click Confirm.v) Click Upgrade on the left menu bar, then choose Reboot to reboot the device.