York HV 515 Installation And User Manual

York HV 515 Installation And User Manual Manual pdf 1 page image

Installation and User Manual for VicePage 1 (of 7)HV 515 and 516Clamping system HV 515 and 516 (see Fig. 1):1. Base plate 5. Guide rods2. Face 6. Head with hole for capstan 28-25mm (1,1“- 0,98“)3. Spindle 7. Retaining ring4. Nut1. Foreword :Read carefully all instructions of this User Manual, especially sections concerning work safety.These sections are marked by a warning triangle.2. Important notice !!- the head (6) has an opening for the capstan ∅25-28mm (1“-5/8“)- to ensure safe fixing of the vice, the minimum workbench thickness is 30mm (5/4“)- after unpacking, the vice must be cleaned of all preservative grease and rust on the guide rods- prior to installation, the HVQ vice must be dismantled into two parts by removing the retainingring (7) and subsequent turning the spindle clockwise (CW) until the entire base plate (1) slides offthe guide rods (5)- assembly is done by reverse procedure and turning the spindle counter clockwise (CCW). Forcentering and inserting the spindle (3) into the nut (4), it is sometimes necessary to use anassistance tool, for example a screwdriver- vice installation is easier when the workbench is turned upside down- to ensure correct vice operation it is recommended to lubricate the spindle (3) and guide rods (5)with oil once a weekFig. 126 35 1 47CCW CW