ZMIN X Series Setup Manual
  | |
ZMIN Label Printer Setup Guide —— X Series1. Unpacking the Printer2.Consumables installationBefore setting up the printer you should consider the following:Make sure there is adequate space around the printer for loading consumables and proper ventilation.Make sure the printer is close to the host so the interface cable is easily accessible at either end.Ribbon RouteLabel Route(Alternative 1)Label Route(Alternative 2)Thermal Transfer Media Loading InstructionsLoading the Ribbon:Remove the protective materials：Please check the items, if there are any items missing, notify your authorized reseller.Save all packing and protective materials in case you need to ship the printer in the future.printer power cord Ribbon Spindle Media Spindle Media Roll Guide Software CD-ROM(1) Push the left and right Top Cover’s Latch Buttonto lift the top cover.(2) Pull the left and right Printhead Latch levers torelease the Printhead Module. Lift the PrintheadModule to expose the Ribbon Supply Compartment.(3) Unwrap the ribbon roll pack and separate theribbon roll and the core. Slide the roll of Ribbononto one of one Ribbon Spindle.Make sure the ink side of your ribbon facesoutwards. Always make sure the ink side of theribbon faces the media and NOT the printhead.(4) Load the Ribbon Spindle into theprinter and route the ribbon through thePrinthead Module.(5) Wrap the end of the ribbonaround the ribbon take up core.Load the ribbon take up coreinto the Ribbon rewindCompartment. (6) Rotatethe Ribbonrewindwheel onthe left ofthe core totake up theloose ribbonand tightenthe ribbon.Close thePrintheadModule andpress downuntil it locksinto place.Continue to the other sideImportant NoticeThermal printhead can be easily damaged due to its precision construction. A printhead damaged by misuse is not covered under the terms of the warranty. To ensure longevity of the printhead, pleasenote the following:1. DO NOT scrape or use tools that might damage the printhead surface.2. To protect from corroding the printhead, DO NOT touch the printhead with bare hands.3. Keep printhead from any form of liquid or dampness.4. Use a Cotton Swab dipped in absolute alcohol to clean the printhead only.5. Always use high-quality consumables: (1) When the printhead module is closed, pressure is placed directly onto the printhead; dirt such as paper scraps, sand, dust and glue can scrape or damagethe printhead. (2) The printhead is also easily damaged by thermal paper or thermal transfer ribbon, which contains Na, K or Cl.So,always inspect consumables for quality before purchasing. |
Related manuals for ZMIN X Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine