© 2022 System Q Ltd1Electric BoltsZap is a registered trademark of System Q LtdDocument ref: qACC514-516ZapCCTV.comACC514, ACC516 - Quick Start GuideElectric BoltsThe ACC514 has an adjustable delay and status relay outputwhich can be connected to a buzzer or light to produce avisible or audible alert when the door is opened.The ACC516 has an adjustable delay of up to 6 seconds, arelay output to alert when the door is opened and LEDindicator to show the bolt status.User Information· There are no user serviceable parts, opening or attemptingto repair the product will void the warranty.· Do not install or use the device if the wires connected aredamaged or have been subjected to water ingress· Handle the equipment carefully, holding force can be reduced by damaging the bolt body ordetector plate.· The electric bolt lock should be fixed tightly on the door frame and the detector plate on the doorleaf.· Shut off all power to the access control system before wiring this device.· Maintain a clean and safe environment at all times.DefinitionNO (Normally Open) - This is a contact which remains open (as default) until activated, during the"active" state the contact provides a closed circuit and starts conducting.NC (Normally Closed) - Is the opposite of a NO contact. The contact will remain closed (as default)until activated, during the "active" state the circuit breaks and stops current flow.ConnectionsACC514 ACC516Red = +12V DC Yellow = NO Red = +12V DC Yellow = NCBlack = GND White = COM Black = GND White = COMPurple = NCSetup ExampleElectric bolts are an efficient method of adding secure accesscontrol to a door.An electric bolt will protrude out as long as there is power beingsupplied and then detector plate is present.For a "Fail Safe" setup, when the button is activated, powersupply then releases power from the lock, and if power is lostthen the lock also releases.You would connect the control device and power to the bolt via anaccess control panel, relay or exit button so that the power can becut when triggered. When powered up again the bolt protrudeagain locking the door in place.