Zap N Trap 605WS30WD Manual
  |
Insect TrapWall SconceItem No: 605WS30WD /WH /GD /BKWattage: 30WInput: 120VDimensions: 25” W x 7½” D x 6¾” HUsage: IndoorReplacement Bulb: #60515WATTReplacement Glue Board: #517RGB100SAFETY PRECAUTIONSCAUTION: This equipment gets HOT. Make sureall flammable/combustible materials are set awayfrom this equipment.• Do not operate any appliance with a damaged cord or plug,nor after the unit malfunctions, is dropped, or is damaged inany manner.• To reduce the risk of injury, close supervision is necessarywhen the unit is used near children.• Only use attachments recommended or sold by themanufacturer.• Do not insert fingers or foreign objects into the unit.• Do not put this product in water or other liquids.Do not place the insect zapper where it can fall into water.• Do not abuse the power supply cord or carry product by thecord. Keep cable away from heat, oil and sharp edges.Never allow the cable to hang in front of the cover.• Do not unplug by pulling on cord. To unplug, grasp the plug,not the cord.• Always disconnect the product from the power source whennot in use, before maintenance, and when cleaning.• Always unplug before replacing the lamp.Replace bulb with same type and rated wattages.• Store the unit indoors and out of the reach of children whennot in use.INSTALLATION GUIDELINESThese precautions should be followed at all times.Failure to follow these precautions could result ininjury to yourself and others.TO REDUCE THE RISK OF ELECTRIC SHOCK,THE PLUG MUST BE PLUGGED INTO ANAPPROPRIATE OUTLET THAT IS PROPERLYINSTALLED AND GROUNDED. CONSULTA QUALIFIED ELECTRICIAN IF IN DOUBTWHETHER PROPER GROUNDING EXISTS.1. Remove all packaging and protective film from the insectzapper. Do not rest the unit on surface without continuingto support it. It will not stand on it’s own.2. Select a proper location to hang the unit. The unit must NOTbe installed where dangerous concentrations of flammableor explosive substances are likely to be present in the air.3. Connect the appliance to main power.4. The unit will be ON once it is connected to an electricalsource. There is no separate ON/OFF switch. The bulb willtake a few minutes to light up completely. The insect zapperis designed for commercial usage such that the unitcould remain ON 24 hours a day.PROPER GROUNDINGThis item is provided with a three-pronged grounding plug.The outlet to which this plug is connected must be properlygrounded. If the receptacle is not the proper grounding type,contact an electrician. DO NOT, under any circumstances, cutor remove the third ground prong from the power cord or useany adapter plug.BEFORE OPERATING ANY EQUIPMENT, READ & FAMILIARIZE YOURSELF WITH THE USE & SAFETY INSTRUCTIONSZAP N TRAP would like to thank you for purchasing this equipment. It’s important to save these instructions for future reference. |
manualsdatabase
Your AI-powered manual search engine