Zebra Machinist Mixer Manual
  |
Zebra Skimmers Corp. Zebra Machinist MixerZebra Machinist MixerManualRequirements• Minimum of 25 psi continuous operating water pressure• Maximum 500 SUS coolant concentrate viscosity• USE DISCHARGE HOSE PROVIDED. Longer lengths will less-en concentration or provide none at all.• Use proper fittings for water input and output. Restriction ofeither will reduce vacuum pressure. Required fitting sizes arenoted below.• Keep drum uprightInstallation Instructions1. Configure the standpipe to fit your concentrate containertype. Universal mixers will need to be adjusted dependingupon the required standpipe length. Use both standpipesand the coupler for tote applications. You may need to re-move and reattach the check valve to the lower end of thestandpipe configuration.2. Remove the bung cap from the concentrate container.3. Insert the required length standpipe into the container andscrew bushing into the 2” female thread in drum. Tighten the set screw.4. Unfasten the breather cap from the concentrate lid.5. Connect the included shut-off valve to the mixer head.6. Connect the water line to the shut-off valve using the proper sized fitting (see chart below).7. Attach the 40” discharge hose, provided. Longer lengths will lessen concentration output. If delivering mixthrough a garden hose, for instance, a proportioning pump is required.8. Open the water valve, and after emulsion is dispensed, check the proportion with a refractometer, thenadjust the dial as necessary. Once the dial setting has been determined, secure with the locknut locatedbelow the dial.• Dial settings are for reference only. Varying water pressure and fluid viscosities will produce differentmixing ratios.• Turning the dial clockwise (right) will bottom out the needle valve onto its seat in the mixer body, pre-venting coolant concentrate from entering the mixing chamber. At this point, the number zero should bein-line with the pointer.• Turning the dial counter-clockwise (left) will open the inlet orifice permitting increasing amounts of cool-ant concentrate to enter the mixing chamber.• Maximum ratio delivered with four full turns of the dial.®(SS modelsfor causticconcentrate)Part# Ratio Range % Range GPM Fitting In Fitting Out ApplicationMIX0327 15:1 - 45:1 0-7 3 3/8” 1/2” BarrelMIXU0327 15:1 - 45:1 0-7 3 3/8” 1/2” Pail, barrel, or toteMIX03725SS 3:1 - 15:1 0-25 3 3/8” 1/2” BarrelMIXU03725 3:1 - 15:1 0-25 3 3/8” 1/2” Pail, barrel, or toteMIXU03725SS 100:1 - 4:1 0-25 3 3/8” 1/2” BarrelMIX1027 15:1 - 45:1 0-7 10 1/2” 3/4” BarrelMIXU1027 15:1 - 45:1 0-7 10 1/2” 3/4” Pail, barrel, or toteMIX10725 3:1 - 15:1 0-25 10 1/2” 3/4” BarrelMIX10725SS 100:1 - 4:1 0-25 10 1/2” 3/4” BarrelMIXU10725 3:1 - 15:1 0-25 10 1/2” 3/4” Pail, barrel, or toteMIXU10725SS 100:1 - 4:1 0-25 10 1/2” 3/4” Pail, barrel, or tote |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine