Zhejiang Lianda Science Technology Co Ltd RTA SCE-R1 Instruction
Remote Control instruction/ / .Read the safety instructions on the enclosed sheet carefully before you start installation.If these instructions are not followed,LIANDAindustry’s liability and warranty are forfeited.LIANDA is not liable for any change in the regulations and standards introduced following the publication of this manual.LIANDA hereby declares that the short range product complies with directive 1999 5 CEThis product must be installed and programmed by qualified personnel.Read these instructions carefully before making the connections.Warning, ,, to,.)The Remote Control is a short range emitter radio controldevice for various applications such as blinds shuttersprojection screens awnings and more.It can be used allthe Lianda RTL receivers(Some Receivers have limitedfunctions with the RTL please read the complete instructionfor more information1.Product Description 2.Technical Information.Frequency:433.92 MHz.Temperature:-10 to +50. attery Type:CR2032 Lithium 3V DC 1 5channels / 27A 12V DC 15 channels.Product Class:II with installation completed℃ ℃B ( &) ( )( )Rev :X01.Zhejiang Lianda Science Technology Co Ltd& .,The Remote Controls are able to control 15 groups of motors at mostRTL motors or motors equipped with RTL receives( ).The Remote Controls can be used to setup the limit of the RTL Radiomotor with radio limit setting .3.FunctionsSCE-R5SCE-R1[ ]: ( )( )( )( & )a UP control keyb STOP control keyc DOWN control keyd LED 1 5channelsLCD(15channes)ef[ ]:[ ]:[ ]:[ ]:[ ]: ( )[ ]PROGSelection key 5channelsg :DEC(decrease channel)[h] :INC (increase channel )4.Open the emitter Replace the battery/. .. .( - ). .1) Open the back cover2) Remove the old battery and place the new battery1 5channels:CR2032 Lithium 3V,15 channels: 27A 12V3) Close the back coverAdd Economic Development Zone2 Nanxun HuZhou Zhejiang Province China: , , , , Customer service number: 86 572 3787117+ - -P C 313009 Fax 86 572 3911465 E MAIL info lianda lianda com Website http www lianda com. : : - - - : - @ . : :// . .5.ProgrammingImportant remark The programming and direction checkingshould be done after the motor is installed:.completly1 .Record a Remote Control in a tubular motor)- .- + .-.Switch the power onPress UP DOWN buttons of the remote control togetherA Feedback will confirm that remote control has been memorizedinside the memory of the tubular motorON0 5 sec. . FeedbackFeedback jog is a short up and down movement of the motor= : .SCE-R151). LCD instruction(15 channels):.Channel number displays the number of current channel..Command icon displays that the control is sending command.The UP icon flashes when UP button is pressedThe STOP icon flashes when STOP button is pressedThe DOWN icon flashes when DOWN button is pressedWhen PROG button is pressed, three icons would flash together..Low battery icon will display when the power of battery is low.;;;2). “Sleep” and “Wake up”(15 channels):The LD-15C RTL remote control has the function of “ ”and “ ” .. : If there is no button action in 5 seconds, the RemoteControl will fall into mode,the power will be shut downand LCD will be turned off.. : During the mode, pressing any button, theRemote Control will be woke up, LCD will display the channelnumber which is displayed before it is turned off.SleepWake upSleepSleepWake up SleepChannel numberLow battery iconCommandUp Stop & Down( , )SCE-R1,R5 SCE-R15[ ]a[ ]b[ ]c[ ]d[ ]e[ ]a[ ]b[ ]c[ ]d[ ]e[ ]f[ ]a[ ]b[ ]c [ ]e[ ]h[ ]g124mm24mm48mm- += .433 92MHz50m= .433 92MHz5m2.This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:((1) This device may not cause harmful interference, and((2) This device must accept any interference received, including interference that may cause undesired operation.(Attention that changes or modification not expressly approved by the party responsible for compliance could void the user's authorityto operate the equipment.Note: This product has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmful interference in a residential installation. This productgenerates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, maycause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particularinstallation. If this product does cause harmful interference to radio or television reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.RTARTARTARTA RTA |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine