TVVOLTVLearn More About NextGen TVwww.watchnextgentv.comNextGen TV BoxQuick Start GuideZAT-600BProgramming the Remote ControlThe remote is capable of controlling up to six basic functions of mostTVs and audio devices (volume, mute, power, input). Use the instructionsbelow for programming the six designated learning keys to operate yourTV or audio device.Press and hold the black "TV POWER" button for 3 seconds until the red LED changes fromflashing to solid. The solid red LED indicates the remote control is in learning mode.Once in learning mode, press and release one of the six learning keys to be programmed.The indicator light will change from solid to slow flashing.Point the front of the TV remote control at the front of the Zinwell remote (about 1~2in). Thenpress and hold any button on the TV remote control to be learned by the Zinwell remote. Afterthe signal is learned, the indicator light will flash 3 times quickly then you can release the button.Press OK button of the Zinwell remote to save programming.Repeat steps 2, 3 and 4 to learn other keys in the TV area. Press OK button of the Zinwellremote to save programming.Programming:1.2.3.4.**Red LED Feedback:Solid LED: Remote is in learning mode,awaiting a key to be selected forprogramming.Slow Flashing LED: Remote is awaiting fromTV remote control.LED flashes 3 times: Learning is successful.During the learning process, if you wait for more than 10seconds at any time, it will automatically exit the learningstate.During the learning process, press any button outside thelearning area at any time to exit the learning state directly.The two remote controllers must not shake during learning.Note:1.2.3.1.2.3.Learning Keys:About 1~2inTV Remote Control