Subito Cotto 60, 80 and 100 ModelInstructions - EnglishPage 1It is important that the oven “Subito Cotto” oven will be installed and used only in accordance with theseattached instructions.We recommend you to read carefully the following instructions before using the oven,make sure that you know how to operate to ensure that it functions properly.The safety instructions, by themselves, do not eliminate danger completely, andproper accident prevention measures must always be used.SPECIFIC STABILITY INSTRUCTIONS• Make sure that the metal stand is well assembled (it is important toassemble the stand following the instructions as showed in “Standassembly and oven positioning” section).• The oven is equipped with 4 handles, move the oven with the aid of 4people or using a forklift. This duty should be performed by professionalstrained in this kind of works.• Improper handling of the oven and equipment could result in damagingthe oven or personal injury.• Position the oven above the stand as described in the section (“Stand assembly and ovenpositioning”).FLOOR OR SUPPORT BASEThe floor positioned above the stand (with the oven at the top) must have a resistance of at least 10kg/cm2.The floor positioned above the stand (with the oven at the top), must have a slope of less than 1%.STAND ASSEMBLY AND OVEN POSITIONINGThe metal stand supplied with the Subito Cotto oven is studied and designed specifically for these models, itsupports the weight of the oven. Without any other support base, it needed to be assembled to positioncorrectly the oven.ASSEMBLY FASE1. Pre-assemble the entire stand, taking care to mount all the supplied screws, without tightening them withforce.2. Once the stand is positioned exactly in a vertical position, tighten the screws securely.The simple procedure is showed in the photos below:Once the stand is assembled you can position the oven (with 4 little legs in the base) above the assembledmetal stand, fitting the little legs in the legs of the stand.