Zircon Leak Alert + Quick Start Manual

Also see for Leak Alert +: User manual

Zircon Leak Alert + Quick Start Manual Manual pdf 1 page image

Leak Alert™+Electronic Water DetectorUndetected water can cause thousands of dollars indamage. Protect your home from potential water damageby keeping a Leak Alert™+ water detector anywhereflooding is a potential danger—near aquariums,sump pumps, plumbing, washing machines, water heaters,toilets, basements, and garages.1. INSTALLING THE BATTERYInsert a coin between topand bottom halves of case.Turn coin to separate.Connect 9Vbattery to clip.Position battery according to the diagram onthe right. Proper battery position will allowthe unit to float in the event of a flood.Securely close case.2. TESTINGWet your finger and touch the twosensing contacts.A loud, repetitive series ofbeeps will sound and the LEDswill flash red. Dry thecontacts to stop the alarm.In the event of low battery,water detector will chirp (short beepevery five seconds). Please replacewith brand new 9V battery immediately.3. PLACEMENTPlace Leak Alert™+ waterdetector facing up andflat against the surface,with metal sensingcontacts down.Leak Alert ™+ waterdetector will notfunction properlywith contacts up.4. FLOODINGLeak Alert™+ water detectorwill float (if battery isinserted according todiagram inside batterycompartment) and alarmwill sound for life ofbattery, up to 72 hours.5. HELPFUL HINTSAlarmSensing ContactsFlashing LEDsBattery AccessSituation Probable Cause SolutionsAlarm sounds,but there is nowater present.Unit does not soundalarm even whentouching water.Unit does not float.• Battery voltage is low.• Water detector is ona conductive surface(i.e. metal).• Ambient moisturehas collected onmetal contacts.• Metal contacts areup, not having directcontact with water.• Battery is dead.• Battery is not placed incorrect area of case.• Change the battery.• Place a piece of thin paperor plastic between waterdetector and metal surface.• Wipe metal contacts dry.• Make sure metal contactsare flat on surface wherewater is to be detected.• Replace battery.• Place unit in face-upposition, open batterycompartment, and positionbattery per diagram.REPLACE BATTERY AND RETEST UNIT ANNUALLY.Leak Alert and Zircon are registered trademarks or trademarks of Zircon Corporation.Visit www.zircon.com/supportfor the most current instructions.LIMITED 1 YEAR WARRANTYZircon Corporation, (“Zircon”) warrants this product to be free from defects inmaterials and workmanship for one year from the date of purchase. Any in-warrantydefective product returned to Zircon*, freight prepaid with proof of purchase dateand $5.00 to cover postage and handling, will be repaired or replaced at Zircon’soption. This warranty is limited to the electronic circuitry and original case of theproduct and specifically excludes damage caused by abuse, unreasonable useor neglect. This warranty is in lieu of all other warranties, express or implied,and no other representations or claims of any nature shall bind or obligate Zircon.Any implied warranties applicable to this product are limited to the one year periodfollowing its purchase. IN NO EVENT WILL ZIRCON BE LIABLE FOR ANY SPECIAL,INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM POSSESSION,USE OR MALFUNCTION OF THIS PRODUCT.In accordance with government regulations, you are advised that: (i) some statesdo not allow limitations on how long an implied warranty lasts and/or the exclusionor limitation of incidental or consequential damages, so the above limitationsand/or exclusions may not apply to you, and further. (ii) this warranty gives youspecific legal rights and you may also have other rights which vary from stateto state. Return product freight prepaid with proof of purchase date (dated salesreceipt) and $5.00 to cover postage and handling, to:Zircon Corporation*Attn: Returns Department1580 Dell AvenueCampbell, CA 95008-06992 USABe sure to include your name and return address. Out of warranty service and repair,where proof of purchase is not provided, shall be returned with repairs chargedC.O.D. Allow 4 to 6 weeks for delivery.Customer Service: 1-800-245-9265 or 1-408-963-4550Monday–Friday, 8:00 a.m. to 5:00 p.m. PSTinfo@zircon.com • www.zircon.com© 2015 Zircon Corporation • P/N 66912 • Rev A 04/15ENZirconCorporation ZirconTV ZirconTools | ZirconToolPro ZirconTools9V Battery

/ 2

Related manuals for Zircon Leak Alert +