© 2014 UTC Fire & Security. All rights reserved. 1 / 4 P/N 501-1782ZE-1-07 • REV 07 • ISS 23JAN14ZP755V Addressable Visual IndicatorInstallation SheetDescriptionThe ZP755V is an addressable visual indicator designed foruse in Ziton analogue addressable fire detection and alarmsystems. The visual indicator provides visual warnings from asingle, addressable, loop-wired unit.Note: The visual indicator of this product does not comply withEN 54-23 and must not be used in fire alarm installationswhere fire notification beacons are required.The visual indicator includes an address-setting switch and apair of jumpers to select the operating power — from theanalogue addressable loop or an external supply. See Table 1for a list of models.Table 1: ModelsModel DescriptionVisual indicatorZP755V-WZP755V-PVisual indicator, WhiteVisual indicator, Polar whiteBaseZP7-SSB-WZP7-SSB-PBase, WhiteBase, Polar whiteInstallationTo install the visual indicator;1. Wire the base2. Set the operating power3. Set the address4. Set the device mode5. Mount the visual indicator onto the baseThe details of each step are given below.Wiring the baseConnect loop wiring for the base as shown in Figure 1. Thereis no wiring between the visual indicator and base. The base issupplied separately.Figure 1: Loop wiring for the plug-in base1. Ext. 24 VDC+ IN/OUT4. Ext. 24 VDC ground IN/OUT5. Loop+ IN/OUT7. Shield8. Loop− IN/OUTSetting the operating powerThe visual indicator includes a pair of power selection jumpers,J1 and J2. To select the source of the sounder operatingpower, position the jumpers as shown in Figure 2.Figure 2: Power selection jumper configuration1. Loop powered 2. External 24 VDCNote: When using an external power supply, use only one thatis CE and EN 54-4 compliant to power all the visual indicatorson the same loop.3498 014781524V0VEXTPOWERED24V0VEXTPOWEREDEXTPOWEREDLINEPOWEREDLINEPOWERED