Zoeller QWIK JON ULTIMA 202 Installation Instructions Manual
Also see for QWIK JON ULTIMA 202: Installation instructionsInstallation instructionsInstallation instructionsInstallation instructions
© Copyright 2017 Zoeller ® Co. All rights reserved.QWIK JON® ULTIMA 202 SYSTEMSINSTALLATION INSTRUCTIONS1. To reduce the risk of electrical shock, a properly grounded receptacle orcontrol box of grounding type must be installed and protected by a groundfault circuit interrupter (GFCI) in accordance with the National ElectricalCode and applicable local codes. Never remove ground pin from plug.2. Make certain that the ground fault interrupter protected receptacle is withinreach of the pump’s power supply cord. DO NOT USE AN EXTENSIONCORD. Extension cords that are too long or too light do not deliver sufficientvoltage to the pump motor and could present a safety hazard if the insulationwere to become damaged or the connection end were to fall into a damp orwet area.3. Make sure the pump's electrical supply circuit is equipped with fuses or circuitbreakers of proper capacity. A separate branch circuit, sized according tothe National Electrical Code for the current shown on the pump name plate,is recommended.4. Testing for ground. As a safety measure, each electrical outlet should bechecked for ground using an Underwriters Laboratory Listed circuit analyzerwhich will indicate if the power, neutral and ground wires are correctlyconnected to your outlet. If they are not, call a qualified, licensed electrician.5. FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM ITSPOWER SOURCE BEFORE HANDLING. If pump is wired direct, de-energizethe circuit at the control box. Grounded pumps are supplied with a 3-pronggrounded plug to help protect you against the possibility of electrical shock.DO NOT, UNDER ANY CIRCUMSTANCES, REMOVE THE GROUND PIN.To reduce the risk of electrical shock, a properly grounded receptacle ofgrounding type must be installed and protected by a ground fault circuitinterrupter (GFCI) or residual current device (RCD) in accordance withNational Electrical Code and applicable local codes.6. Installation and servicing of electrical circuits and hardware should only beperformed by a qualified, licensed electrician.7. Check to be sure your power source is adequate to handle the amperagerequirements of the motor as indicated on the pump or name plate.NOTICE TO INSTALLER: Instructions must remain with installation. FM23691117Supersedes0917P/N 018507MODEL NO. ____________________DATE CODE: __________________DATE INSTALLED: _____________SEE BELOW FOR LIST OF WARNINGSProduct information presentedhere reflects conditions at timeof publication. Consult factoryregarding discrepancies orinconsistencies.MAIL TO: P.O. BOX 16347 • Louisville, KY 40256-0347SHIP TO: 3649 Cane Run Road • Louisville, KY 40211-1961TEL: (502) 778-2731 • 1 (800) 928-PUMP • FAX: (502) 774-3624Visit our web site:zoellerpumps.comSAFETY INSTRUCTIONSREFER TO CAUTIONS AND WARRANTY ON PAGE 2.TO AVOID SERIOUS OR FATAL PERSONAL INJURY OR MAJORPROPERTY DAMAGE, READ AND FOLLOW ALL SAFETYINSTRUCTIONS IN THIS MANUAL AND ON THE PUMP.THIS MANUAL IS INTENDED TO ASSIST IN THE INSTALLATION ANDOPERATION OF THIS UNIT AND MUST BE KEPT WITH THE PUMP.This is a SAFETY ALERT SYMBOL. When you see thissymbol on the pump or in the manual, look for one of thefollowing signal words and be alert to the potential forpersonal injury or property damage.Warns of hazards that CAN cause serious personal injury,death or major property damage.Warns of hazards that CAN cause personal injury orproperty damage.Warns of electrical shock hazards that CAN cause seriouspersonal injury, death or major property damage.Identifies any terminal which is intended for connectionto an external conductor for protection against electricalshock in case of a fault, or the terminal of a protectiveearth (ground) electrode.Read operator's manual.THOROUGHLY REVIEW ALL INSTRUCTIONS AND WARNINGS PRIORTO PERFORMING ANY WORK ON THIS PUMP.MAINTAIN ALL SAFETY DECALS.CAUTIONPREINSTALLATION CHECKLIST - ALL INSTALLATIONS1. Inspect all materials. Occasionally, products are damaged during shipment. If the unit is damaged, contact your dealer before using. DO NOT remove the test/oil fill plugs from the pump.2. Carefully read the literature provided to familiarize yourself with specific details regarding installation and use. These materials should be retained for future reference.Register yourZoeller Pump CompanyProduct on our website:http://reg.zoellerpumps.com/U.S. Patent Nos.7,203,976; 9,352,327;8,562,287Canadian Patent No.2,512,023 |
Related manuals for Zoeller QWIK JON ULTIMA 202
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine