SPECIFICATIONSRECOMMENDED USEPRESSURE RATINGTEMPERATURE RATINGSUITABLE HOT WATER UNITSAS/NZS 3718:2005WM-022852Note: Dimensions are nominal measurements onlyBARRE ASSEMBLY TAP SDomesticRecommended minimum working pressure 150kPaRecommended maximum working pressure 500kPaHot and cold water inlet pressure should be equalStorage tank: YesContinuous Flow: YesGravity Feed: Not suitableMaximum continuous working temperature 75°CIf the water temperature exceeds 75°C, an approved temperingvalve must be fittedDisclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or deletemodels from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributortakes no responsibility for printing errors. All ABI Products are designed in Australia. Copyright ABI Interiors Pty Lty 2021.MATERIAL Solid BrassNew Build - Install breach in desired position (please refer to additional install information regarding breach set backs).Retrofitting Existing - Remove existing tapware & reseat body seats until shiny and smooth.DO NO T use creamcleaners or bleach.These sub stances a reabrasiveDO NO T use cle aningpads with ab rasivesur faces as this ma yscratch the mate rialRegularly c lean withmild liq uid det ergentor soap and wa terINSTALLATION GUIDENote: This product must be installed by a licensed plumber.This is a general installation guide - there are many factors that are involved that can alterthe installation method. This product install must comply with AS/NZS 3500.Remove locking nut from spindle. Screw spindle into breach and handtighten until rear of spindle meets the body seat, be sure not to over tighten.If necessary apply more pressure lightly with spanner.Fit the fibre washer over the spindle. Screw on the locking nut and tightenwith spanner. TEST AND CHECK FOR LEAKS.1 2Install the handle body onto the locking nut, twisting by hand untiltightened. Slide back plate over handle body until firmly pressed againstfinished wall surface.3 Install tap handle onto spindle and tighten in place using grub screw andallen key.4Front View Side Viewensions are nominal measurements only54G5/8358 2480113616