Installation and Operation InstructionsPart #A/ASCS, A/ASCS-L, A/ASCSX, A/ASCSX-L2305 Pleasant View Rd. Middleton Industrial Park Middleton, WI 53562PH: (608) 831-2585 FAX (608) 831-7407File Name: I0000138 Rev 6.DocPage 1 of 3ACIAutomation Components, Inc.Please Read Instructions Carefully Before Installation! Safety This product is not intended to be used for Life or Safety applications. This product is not intended for use in any hazardous or classified locations. Disconnect and lock out all power sources before installation as severe injury or death may result from electricalshock due to contact with high voltage wires. InstallationMake sure that all installations are in compliance with all national and local electrical codes. Only qualified individuals that arefamiliar with codes, standards, and proper safety procedures for high-voltage installations should attempt installation. The currentswitches will not require external power, since the power for the current switch is induced from the conductor being monitored.Warning: Never rely on the LEDs to determine whether power is present at the current switch. The Red LED willindicate whether the current is above the adjustable trip point. The Green LED will indicate whether thecurrent is below the adjustable trip point.The A/ASCS Series Current Switches should be used on Insulated Conductors Only! The current switch may be mounted in anyposition using the (2) #8 x 3/4” Tek screws and the mounting holes in the base or snapped directly on to the 35mm DIN rail (SeeFigures 1 & 2 below). Leave a minimum distance of 1” (3 cm) between the current switch and any other magnetic devices such ascontactors and transformers.Automation Components, Inc.3JHXIND.CONT.EQ.LISTEDC USA/ASCSMiddleton, WIACI3X3XLISTEDC USIND.CONT. EQ.3JHXAutomation Components, Inc.ACI A/ASCSMiddleton, WIFigure 1: Sensor Placed on Rail Figure 2: Sensor Removed from Rail Latch Operation:Pressing down on the two (2) side tabs and swinging the cover open opens the split core current switch as shown inFigure 3 below. Lifting up on the latch with a flat-tip screwdriver as shown in Figure 4 below can also open the unit. Press downfirmly on the cover to close the current switch. An audible “click” will be heard as the tab slides over the tongue on the base.Caution: Mating surfaces of the magnetic core are exposed when the sensor is open. Silicone grease, present on the cores toprevent rust, can capture grit and dirt if care is not exercised. Operation can be impaired if anything prevents goodcontact between pole pieces. Visually check the mating parts of the core before closing the current sensor.3JHXIND.CONT.EQ.LISTEDUSCA/ASCSMiddleton, WIACIAutomation Components , Inc.ACI A/ASCSLISTEDIND.CONT.EQ.3JHXAuto matio n Co mpon ents, Inc.Mid dleton, WIC USCIND.CONT.EQ.LISTEDUS3JHXFigure 3: Opening Sensor by Hand Figure 4: Opening w/ Screwdriver!!