Automation Components, Inc.2305 Pleasant View Road | Middleton, WI 53562Phone: 1-888-967-5224 | Website: workaci.comPage 1Version: 8.0I0000668FIGURE 1: ENCLOSURE DIMENSIONSMOD9200BNT BACnet MSTPNETWORK TRANSCEIVERInstallation & Operation InstructionsPhone: 1-888-967-5224Website: workaci.comFRONT VIEW SIDE PROFILEFRONT4.72"(119.89mm)3.50”(88.90 mm)8.26”(209.80 mm)7.63”(184.50 mm)2.37”(60.10 mm)8.78”(223 mm)Ø: 0.190” (4 PLCS.)RJ45RS232ANTENNAJ1TB2J2InitNormA(+)24 VTB1B(-)A(+)B(-)SHLDACTIVE LEDDATA LINKLEDDo not use this product in any safety related applications where human life may be affected.GENERAL INFORMATIONACI’s Wireless Series MOD9200BNT BACnet® network transceiver utilizes reliable Spread Spectrum MeshNetwork Radio technology. Together with other ACI wireless sensors and controls, the system can be usedto transmit remote sensor readings, status/alarm indications, control signals and outputs wirelessly. It iscompatible with any control panels or Automation Systems that utilize BACnet MSTP (Master Slave TokenPassing) communication protocol. Up to 50 separate physical wireless sensor transmitters and/or wirelessremote output (analog & digital) modules can be used with one MOD9200BNT Transceiver and up to 100data points and 100 outputs can be monitored and controlled with one (1) MOD9200 Transceiver.The maximum radio transmission distance is dependent on the building type. In a typical commercialbuilding with steel I-Beam construction, concrete floors with reinforcing rod, and metal stud walls, it canbe expected that transmissions will penetrate horizontally approximately 200-300 feet of floor, walls,furniture and air.RR2552 signal repeaters can be installed as needed to increase transmission distance between sensors andreceivers - see FIGURE 2 (p. 2). Generally, a wireless system will cover at least three floors–one floor above,and one floor below the receiver location. In some buildings with favorable transmission characteristics thesystem may cover more floors - see FIGURE 3 (p. 2). Wireless sensor transmitters should be installed within200 to 300 feet of the MOD9200 transceiver.PRECAUTIONS• To maintain high performance, do not install sensors, repeaters, or receivers in the following areas:- Inside metal enclosure / panel- Inside or immediately next to elevator shaft or elevator banks- In front of or immediately next to large trees or large body of water