aci RR2552B Installation & Operation Instructions
    |
Automation Components, Inc.2305 Pleasant View Road | Middleton, WI 53562Phone: 1-888-967-5224 | Website: workaci.comPage 1Version: 7.0I0000666RR2552 SPREAD SPECTRUMREPEATERInstallation & Operation InstructionsPhone: 1-888-967-5224Website: workaci.comTABLE 1: REPEATABLE NETWORK ID SWITCH SETTINGSwitch#32Switch#16Switch#8Switch#4Switch#2Switch#1NetworkAddressOFF OFF OFF OFF OFF OFF 1OFF OFF OFF OFF OFF ON 2OFF OFF OFF OFF ON OFF 3OFFOFFOFFOFF ONOFFOFFOFFOFFONOFFONOFFOFFOFFOFFOFFOFFOFF17ON OFF OFF OFF OFF OFF 3359OFF OFF OFF ON ON 4Do not use this product in any safety related applications where human life may be affected.GENERAL INFORMATIONThe RR2552B repeater uses the reliable 900 MHz spread spectrum technology to work with any ACI wirelesssystem to boost or extend the range of wireless sensors and is easily installed. The RR2552B has an 8 positiondipswitch that is user selectable to set the address of the RR2552B to match the Network ID of thereceiver/transceiver in each system so there is no programming required. The RR2552B must be powered with 24VAC. Two Duracell DL123 3V lithium batteries are included for temporary power to position the repeater beforefinal installation and wiring. Without the use of the RR2552B wireless repeater, all systems will be a point to pointsystem, meaning that the sensor and transceiver will communicate directly with each other. Sensor distance andreliability can be increased with the addition of a RR2552B(s) repeater. The RR2552B will work with all ACI wirelesssensors, receivers and transceivers.MOUNTING INSTRUCTIONSPRECAUTIONS• To maintain high performance, do not install sensors, repeaters, or receivers in the following areas:- Inside metal enclosure / panel- Inside or immediately next to elevator shaft or elevator banks- In front of or immediately next to large trees or large body of water- Do not mount above false ceiling. Mount in wall 1” below ceiling.- Use the battery option to determine mounting location before wiring.- Do not put more then two RR2552B repeaters in series.- Contact ACI Tech Support for further assistance.SETTING REPEATABLE NETWORK IDThe RM2432 or MOD9200’s has a network ID assigned to them through the configuration software (defaultnetwork ID of 1). If there are multiple ACI wireless systems running in a building at the same time, eachreceiver or transceiver needs to have its own separate network ID # which is set through the configurationsoftware. If a repeater is added to a system, the repeater has Binary dip switches that must match thenetwork ID of the system the repeater is being added to. If there is only one ACI wireless system running,the network ID is probably set todefault 1. With all the dip switches offon the repeater, the default addressis binary “1” (default).Example: To set the Network ID to “2”,depress the “+1” switch to “ON” toadd “1” to the Base ID of “1”.To set the Network ID to “3”, set the“+1” switch to “OFF”, and the “+2”switch to “ON” to add “2” to the BaseID of “1” equaling “3”. See Table 1 forswitch positions. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine